Drag and Drop Question

Drag and Drop Question Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right. View AnswerAnswer:

April 3, 2020 No Comments READ MORE +

Which list defines the contents of an MPLS label?

Which list defines the contents of an MPLS label?A . 20-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTC . 32-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limit.D . 20-bit label; 3-bit flow label: 1-bit bottom stack; 8-bit hop limitE . 32-bit label; 3-bit traffic class;...

April 3, 2020 No Comments READ MORE +

What is the output of the following command:

What is the output of the following command: show ip vrfA . Show's default RD valuesB . Displays IP routing table information associated with a VRFC . Show's routing protocol information associated with a VRE . Displays the ARP table (static and dynamic entries) in the specified VRFView AnswerAnswer: A

April 3, 2020 2 Comments READ MORE +

Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration?

Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration? A . Router ospf3 1 address-family ipv4 B . Router(config-router)#ospfv3 1 ipv4 area 0 C . Router(config-router)#ospfv3 3 1 D . Router ospfv3 1 address-family ipv4 unicast View Answer Answer: D

April 2, 2020 2 Comments READ MORE +

Drag and Drop Question

Drag and Drop Question Drag and drop the OSPF adjacency states from the left onto the correct descriptions on the right. View AnswerAnswer:

April 2, 2020 No Comments READ MORE +

What is the reason for the error?

When provisioning a device in Cisco DNA Center, the engineer sees the error message "Cannot select the device. Not compatible with template.". What is the reason for the error?A . The software version of the template is different from the software version of the deviceB . The changes to the...

April 2, 2020 No Comments READ MORE +

Drag and Drop Question

Drag and Drop Question Drag and drop the DHCP messages from the left onto the correct uses on the right. View AnswerAnswer:

April 2, 2020 1 Comment READ MORE +

Which statement about R1 is true?

Refer to the exhibit. Which statement about R1 is true?A . OSPF redistributes RIP routes only if they have a tag of oneB . RIP learned routes are distributed to OSPF with a tag value of oneC . R1 adds one to the metric for RIP learned routes before redistributing...

April 1, 2020 1 Comment READ MORE +

Which two actions resolved the issue?

Refer to the exhibit. After applying IPsec, the engineer observed that the DMVPN tunnel went down, and both spoke-to-spoke and hub were not establishing. Which two actions resolved the issue? (Choose two.)A . Configure the crypto isakmp key cisco address 0.0.0.0 on R2 and R3.B . Remove the crypto isakmp...

April 1, 2020 1 Comment READ MORE +

Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?

Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?A . Interface-dispointB . Shared risk link group-disjointC . Linecard-disjointD . Lowest-repair-path-metricView AnswerAnswer: B

March 31, 2020 No Comments READ MORE +