- All Exams Instant Download
Which type of cable connector is displayed that is used to connect antennas to transmitters?
Refer to the exhibit. Which type of cable connector is displayed that is used to connect antennas to transmitters?A . RP-TNCB . NC . SMAD . SMBE . MMCXView AnswerAnswer: B
What is the cause of the drop in video?
A corporation has a Cisco Unified Wireless Network that has been deployed for voice coverage. The wireless data rates have been tuned to mandatory rates of 18 Mbps and 36 Mbps. Some wireless clients have been experiencing drops streaming multicast video while moving throughout the building. What is the cause...
Which information can be referenced to provide the contractor the requested information?
A cabling contractor is working at a customer facility. The contractor is asking what rating of cable should be installed in return-air areas. Which information can be referenced to provide the contractor the requested information?A . OSHA CodesB . BICSI TDDMC . NEC RatingsD . IEEE StandardsView AnswerAnswer: B
What is the coverage area from the AP if the environment and other factors are not taken into consideration?
An engineer is planning for a 24 Mbps data rate on the 5Ghz band for a new installation. What is the coverage area from the AP if the environment and other factors are not taken into consideration?A . 225 feetB . 80 feetC . 150 feetD . 100 feetView AnswerAnswer:...
What is the optimal distance between APs for location services without considering the physical environment?
What is the optimal distance between APs for location services without considering the physical environment?A . 10 to 25 feetB . 90 to 120 feetC . 50 to 70 feetD . 80 to 100 feetView AnswerAnswer: C Explanation: Reference: http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/emob41dg/emob41dgÂwrapper/ch13Loca.html
A network engineer is configuring QoS with a DSCP value of 46. To which queue must the CoS be mapped for priority queuing of the voice frames?
A network engineer is configuring QoS with a DSCP value of 46. To which queue must the CoS be mapped for priority queuing of the voice frames?A . 1B . 2C . 5D . 4E . 3View AnswerAnswer: C
Which two basic characteristics would be needed from antennas used for survey and deployment in various indoor situations? (Choose two.)
Which two basic characteristics would be needed from antennas used for survey and deployment in various indoor situations? (Choose two.)A . Horizontally polarizedB . Vertically polarizedC . Aesthetically fittingD . Least costE . Highest gainF . Largest beam widthView AnswerAnswer: BC
After implementing mesh with an IP surveillance camera connected to the LAN port on a RAP, the engineer notices that QoS is not being marked. In this setup, what device is responsible for marking upstream traffic from the camera?
After implementing mesh with an IP surveillance camera connected to the LAN port on a RAP, the engineer notices that QoS is not being marked. In this setup, what device is responsible for marking upstream traffic from the camera?A . IP CameraB . MAPC . RAPD . Wireless ControllerE ....
Why is the engineer unable to locate the offending device or devices?
While performing a Layer 1 passive wireless site survey of a location an engineer detects several instances of low power frequency hopping interference, but cannot physically locate the interfering device or devices. Why is the engineer unable to locate the offending device or devices?A . The sources are nearby narrow-beam...
When configuring Cisco Prime Infrastructure, which obstacle should be placed in a map editor to represent the impact the glass wall will have on the RF signal in the facility?
When conducting a wireless survey at a customer facility, signal attenuation in an area that is surrounded by thick glass walls is noted as 2dB. When configuring Cisco Prime Infrastructure, which obstacle should be placed in a map editor to represent the impact the glass wall will have on the...
