Which two limitations of IP Source Guard are true? (Choose two)

Which two limitations of IP Source Guard are true? (Choose two)A . It is supported only on ingress Layer 2 portsB . It is supported only on ingress Layers 3 portsC . It is supported only on packets switched in hardwareD . It is supported only on PAgP EtherChannels.E ....

December 22, 2019 No Comments READ MORE +

Which two statements about SPAN source and destination ports during an active session are true? (Choose two.)

Which two statements about SPAN source and destination ports during an active session are true? (Choose two.)A . The source port can be only an Ethernet physical port.B . The source port can be monitored in multiple SPAN sessions.C . The destination port can be destination in multiple SPAN sessions.D...

October 20, 2019 No Comments READ MORE +

Which configuration do you apply to a device to place interface GigabitEthernet0/0 info VRRP group 10?

Which configuration do you apply to a device to place interface GigabitEthernet0/0 info VRRP group 10?A . interface GigabitEthernet0/0 ip address 172.16.13.2 265 255.255.0 standby 10 ip 172.16.13.254 255.255.255.0 standby 10 priority 120 standby 10 preemptB . interface GigabitEthernet0/0 description to Executive Offices A 08-38338 ip address 172.16.13.2 265.255.255.0 vrrp...

October 20, 2019 No Comments READ MORE +

Which spanning-tree feature is configured on this interface?

Refer to the exhibit. Which spanning-tree feature is configured on this interface?A . The command spanning-tree mst1 vlan 10, 20, 30, 40 in the global configuration mode was entered.B . The command spanning-tree portfast trunk in the interface configuration mode was entered.C . The command spanning-tree vlan 10, 20, 30,...

October 19, 2019 No Comments READ MORE +

Which two statements can be derived from the output of the show standby command?

Refer to the exhibit. Which two statements can be derived from the output of the show standby command? (Choose two)A . R2 Fa1/0 regains mastership when the link comes back upB . R2 becomes the active router after the hold time expiresC . if Fa0/0 is shut down, the HSRP...

October 18, 2019 No Comments READ MORE +

Which two limitations of IP Source Guard are true? (Choose two.)

Which two limitations of IP Source Guard are true? (Choose two.)A . It is supported only on packets switched in hardware.B . It is supported only on ingress Layer 2 ports.C . It is supported only on egress Layer 3 ports.D . It is supported only an PAgP EtherChannels.E ....

October 18, 2019 No Comments READ MORE +

Which two statements about HSRP are true? (Choose two.)

Which two statements about HSRP are true? (Choose two.)A . you must manually configure ICMP redirect messages on HSRP interfacesB . It is supported on switch virtual interfaces and routed portsC . Primary and secondary HSRP switches forward traffic in a round-robin styleD . The interfaces in a HSRP group...

October 17, 2019 No Comments READ MORE +

Which two effects of this configuration are true?

Refer to the exhibit. Which two effects of this configuration are true? (Choose two.)A . R1 becomes the active router.B . If R2 goes down, R1 becomes active but reverts to standby when R2 comes back onlineC . Hello messages are sent to multicast address 224.0.0.5.D . If R1 goes...

October 16, 2019 No Comments READ MORE +

Which two commands remove VLAN 100 from the VLANs allowed on the trunk port?

Refer to the output below. interface FastEthernet0/1 description to server room A 76-79430 switchport trunk allowed vlan 81-97,99-121 switchport mode trunk end ! Which two commands remove VLAN 100 from the VLANs allowed on the trunk port? (Choose two.)A . switchport trunk allowed vlan 81-97,99,101-121B . no switchport trunk allowed...

October 15, 2019 No Comments READ MORE +

Which two statements about the network environment are true?

Refer to the exhibit. Which two statements about the network environment are true? (Choose two.)A . UDLD aggressive mode put the interface into an error-disabled stateB . After the error is corrected, the udld reset command recovers the disabled ports.C . The UDLD mode changed from normal to aggressive when...

October 15, 2019 No Comments READ MORE +