Which action can the engineer take to resolve this issue?

Refer to the exhibit. Users of PC-1 experience slow connection when a webpage is requested from the server. To increase bandwidth, the network engineer configured an EtherChannel on interfaces Fa1/0 and Fa0/1 of the server farm switch, as shown here: Server_Switch#sh etherchannel load-balance EtherChannel Load-Balancing Operational State (src-mac):Non-IP: Source MAC...

February 21, 2018 No Comments READ MORE +

What is a cause for this issue?

An access switch has been configured with an EtherChannel port. After configuring SPAN to monitor this port, the network administrator notices that not all traffic is being replicated to the management server. What is a cause for this issue?A . VLAN filters are required to ensure traffic mirrors effectively.B ....

February 21, 2018 No Comments READ MORE +

A question about UDLD. It shows a picture of 7 times and UDLD is set to aggressive mode. The port is set to shutdown error-disabled.

A question about UDLD. It shows a picture of 7 times and UDLD is set to aggressive mode. The port is set to shutdown error-disabled.A . The port is set to shutdown because UDLD is set to aggressive mode.B . The port is set to shutdown because STC . ..View...

February 21, 2018 No Comments READ MORE +

AAA question about the command used to login a user and set immediate access to privilege mode.

AAA question about the command used to login a user and set immediate access to privilege mode.A . aaa authorization exec default group radiusB . aaa authentication default group loginC . aaa authorization group default radiusD . aaa authentication exec default group radiusView AnswerAnswer: A

February 20, 2018 No Comments READ MORE +

Which benefit of Stackwise is true?

Which benefit of Stackwise is true?A . It allows multiple switches to operate independently while sharing a single management address.B . It enables a Layer 2 switch to be converted to a Layer 3 switch when additional switches are added to the stack.C . It allows multiple switches to be...

February 19, 2018 No Comments READ MORE +

Which two statements about VRRP are true? (Choose two.)

Which two statements about VRRP are true? (Choose two.)A . It is assigned multicast address 224.0.0.8.B . The TTL for VRRP packets must be 255.C . It is assigned multicast address 224.0.0.9.D . Its IP address number is 115.E . Three versions of the VRRP protocol have been defined.F ....

February 19, 2018 No Comments READ MORE +

Which two combinations of Ether Channel modes support the formation of an EtherChannel? (Choose two.)

Which two combinations of Ether Channel modes support the formation of an EtherChannel? (Choose two.)A . desirable, passiveB . desirable, desirableC . active, passiveD . passive, passiveE . active, desirableView AnswerAnswer: BC

February 18, 2018 No Comments READ MORE +

In a Cisco switch, what is the default period of time after which a MAC address ages out and is discarded?

In a Cisco switch, what is the default period of time after which a MAC address ages out and is discarded?A . 100 secondsB . 180 secondsC . 300 secondsD . 600 secondsView AnswerAnswer: C Explanation: To configure the aging time for all MAC addresses, perform this task: Command Purpose...

February 18, 2018 No Comments READ MORE +

Which option describes what causes the port to go into the errdisable state?

After UDLD is implemented, a Network Administrator noticed that one port stops receiving UDLD packets. This port continues to reestablish until after eight failed retries. The port then transitions into the errdisable state. Which option describes what causes the port to go into the errdisable state?A . Normal UDLD operations...

February 17, 2018 No Comments READ MORE +

Which statement describes the result if a switch that is running PVST+ is added to this network?

Refer to the exhibit. Which statement describes the result if a switch that is running PVST+ is added to this network?A . Spanning tree is disabled attomatically on the networkB . Spanning tree contines to operate in Rapid PVST+ on DSW2 and the new switch operates in PVST+C . Both...

February 15, 2018 No Comments READ MORE +