- All Exams Instant Download
Which two statements about the network environment of the device that generated this output are true?
Refer to the exhibit. Which two statements about the network environment of the device that generated this output are true? (Choose two.)A . The hello and hold timers are set to custom values.B . If the local device fails to receive a hello from the active router for more than...
A question about SDM templates and switch overloading.
A question about SDM templates and switch overloading.A . sdm prefer defaultB . sdm prefer routingC . sdm prefer vlanD . sdm prefer enableView AnswerAnswer: A
Which effect of this configuration is true?
Refer to the exhibit. Which effect of this configuration is true?A . The switch port continues to negotiate an EtherChannel even when there are configuration discrepancies between the two portsB . Spanning tree blocks EtherChannel formation on the deviceC . The switch port error disables when a port attempts to...
Which version of VTP supports the use of private VLANs?
To provide security, a service provider various private VLANs in its backbone network infrastructure to prevent certain VLANs communicating to each other. Which version of VTP supports the use of private VLANs?A . version 1B . version 3C . VTP does not support private VLANsD . version 2View AnswerAnswer: B
A question about HSRP that have these options.
A question about HSRP that have these options. A . R1 have x.x.x.x in routing table.B . http://bbs.hh010.comC . http://bbs.hh010.comD . http://bbs.hh010.comView AnswerAnswer: A
If switch SW1 is connected in a mesh with four other switches and all switches retain the default configuration, which command do you enter on SW1 interface to make it the root bridge for all VLANs?
If switch SW1 is connected in a mesh with four other switches and all switches retain the default configuration, which command do you enter on SW1 interface to make it the root bridge for all VLANs?A . SW1(config)#spanning-tree port-priority 129B . SW1(config)#spanning-tree port-priority 127C . SW1(config-if)#spanning-tree port-priority 129D . SW1(config-if)#spanning-tree...
Which EtherChannel load balancing algorithm should be used to optimize the EtherChannel links between switches?
EtherChannel load balancing with an exhibit. SERVER SERVER | | S W I T C H ||||||||||| S W I T C H | HOST Which EtherChannel load balancing algorithm should be used to optimize the EtherChannel links between switches?A . Source MACB . Source-dest MACC . Destination IPD ....
Which two conditions must be met to establish a Layer 2 EtherChannel? (Choose two.)
Which two conditions must be met to establish a Layer 2 EtherChannel? (Choose two.)A . SPAN must be disabled on the ports.B . LAN ports in the EtherChannel must be contiguous.C . The trunking protocol must be the same for all links in the EtherChannel.D . All ports in the...
If the EtherChannel mode on switch 1 is configured to active, which two modes on switch 2 establish an operational EtherChannel?
An engineer is configuring an EtherChannel between two switches using LACP. If the EtherChannel mode on switch 1 is configured to active, which two modes on switch 2 establish an operational EtherChannel? (Choose two.)A . activeB . autoC . desirableD . onE . passiveView AnswerAnswer: AE
Which state are these interfaces in after the VLAN is deleted?
Interfaces are assigned to a VLAN, and then the VLAN is deleted. Which state are these interfaces in after the VLAN is deleted?A . They remain up, but they are reassigned to the default VLANB . They go down until they are reassigned to a VLAD . They go down,...
