- All Exams Instant Download
Which IOS configuration command is required to configure a VLAN as a private VLAN?
Which IOS configuration command is required to configure a VLAN as a private VLAN?A . switch(config-vlan)# private-vlan commonB . switch(config-vlan)# private-vlan privateC . switch(config-vlan)# private-vlan primaryD . switch(config-vlan)# private-vlan transparentView AnswerAnswer: C
Based on the output, which option describes the reason for this error?
Refer to the exhibit. An engineer is configuring EtherChannel between two switches and notices the console message on switch 2. Based on the output, which option describes the reason for this error?A . Switch 1 does not have enough member ports configured.B . Switch 2 has too many member ports...
Which action is needed to modify the Layer 2 spanning-tree network so that traffic for PC1 VLAN from switch SW3 uses switchport f1/1 as a primary port?
Refer to the exhibit. f1/0 and f1/1 have the same end-to-end path cost to the designated bridge. Which action is needed to modify the Layer 2 spanning-tree network so that traffic for PC1 VLAN from switch SW3 uses switchport f1/1 as a primary port?A . Modify the spanning-tree port-priority on...
If VLAN 99 is set to trunk, how can you set it to untagged from trunk VLAN 99? (If VLAN 99 trunk is set, how to untagged trunk VLAN 99?)
If VLAN 99 is set to trunk, how can you set it to untagged from trunk VLAN 99? (If VLAN 99 trunk is set, how to untagged trunk VLAN 99?)A . switchport access vlan 99B . switchport vlan 99 accessC . switchport vlan 99 allow accessD . switchport allow access...
Which two of the following organizationally specific LLDP TLVs are also advertised to support LLDP-MED? (Choose two.)
Which two of the following organizationally specific LLDP TLVs are also advertised to support LLDP-MED? (Choose two.)A . Port VLAN ID TLV (IEEE 802.1 organizationally specific TLVs)B . MAC/PHY configuration/status TLV (IEEE 802.3 organizationally specific TLVs)C . IP Address TLV (IEEE 802.9 organizationally specific TLVs)D . DSCP TLV (IEEE 802.3...
What command would display a single line of information for each virtual gateway or virtual forwarder on a switch?
What command would display a single line of information for each virtual gateway or virtual forwarder on a switch?A . switch# show glbpB . switch# show glbp briefC . switch# show standbyD . switch# show standby briefView AnswerAnswer: B
Which two TLVs are mandatory? (Choose two.)
Which two TLVs are mandatory? (Choose two.)A . Chassis IDB . Port IDView AnswerAnswer: AB
Which feature actively validates DHCP messages and drops invalid messages?
Which feature actively validates DHCP messages and drops invalid messages?A . CGMP bindingB . IGMP SnoopingC . ARP InspectionD . DHCP SnoopingE . DHCP InspectionF . Dynamic ARP inspectionView AnswerAnswer: D
Why is the EtherChannel bundle not working?
After an EtherChannel is configured between two Cisco switches, interface port channel 1 is in the down/ down state. Switch A is configured with channel-group 1 mode active, while Switch B is configured with channel-group 1 mode desirable. Why is the EtherChannel bundle not working?A . The switches are using...
What statement is true if a new switch with a lower bridge ID is introduced in a network with root guard enhancement?
What statement is true if a new switch with a lower bridge ID is introduced in a network with root guard enhancement?A . Prevent unknown switch be a root portB . Root Guard puts the port into root-inconsistentC . Allow two root bridges in a networkD . All ports of...
