- All Exams Instant Download
Which two limitations of LOCAL SPAN are true? (Choose Two)
Which two limitations of LOCAL SPAN are true? (Choose Two)A . The source and destination ports must reside in the same switch or switch stackB . It can monitor only traffic that ingresses or egresses on the source interface or VLAD . A SPAN session can support multiple destination ports...
Which two statements is true about the configuration below?
A switch has a pair of fiber and it has been damaged. Which two statements is true about the configuration below? (Choose two.)A . It would prevent loops.B . It would be in shutdown mode until fiber is replaced.C . It would be up for 15 minutes after fiber is...
Which two attributes must match across the member ports?
When a Layer 2 trunking EtherChannel is configured. Which two attributes must match across the member ports? (choose two)A . Spanning-tree priorityB . Spanning-tree costC . Interface descriptionD . Trunk modeE . allow VLANsView AnswerAnswer: DE
How to configure dynamic ARP inspection on a VLAN?
How to configure dynamic ARP inspection on a VLAN?A . (config)# ip arp inspection vlanB . (config-if)# ip arp inspection vlanC . (config)# arp inspection defaultD . (config-if)# inspection arp vlanView AnswerAnswer: A Explanation: To enable DAI on a per-VLAN basis, use the ip arp inspection vlan command in global...
which command enables root guard on a cisco switch?
which command enables root guard on a cisco switch?A . switch(config-if)# spanning-tree guard rootB . switch(config)# spanning-tree guard rootC . switch(config-if)# spanning-tree guard-rootD . switch(config)# spanning-tree root guardE . switch(config-if)# spanning-tree root guardView AnswerAnswer: A
Which two commands can you enter to configure load-balancing at Layer 2? (Choose two.)
Which two commands can you enter to configure load-balancing at Layer 2? (Choose two.)A . port-channel load-balance dst-ipB . port-channel load-balance src-dst-ipC . port-channel load-balance src-macD . port-channel load-balance src-dest-macE . port-channel load-balance src-ipView AnswerAnswer: CD
What is the default HSRP priority?
What is the default HSRP priority?A . 50B . 100C . 120D . 1024View AnswerAnswer: B Explanation: standby [group-num- Set a priority value used in choosing the active router. The ber] priority priority range is 1 to 255; the default priority is 100. The highest [preempt [delay delay]] number represents...
Which statement about the use of SDM templates in a Cisco switch is true?
Which statement about the use of SDM templates in a Cisco switch is true?A . SDM templates are used to configure system resources in the switch to optimize support for specific features, depending on how the switch is used in the network.B . SDM templates are used to create Layer...
Which configuration on the HSRP neighboring device ensures that it becomes the active HSRP device in the event that port fa1/1 on Switch_A goes down?
Refer to the exhibit. Which configuration on the HSRP neighboring device ensures that it becomes the active HSRP device in the event that port fa1/1 on Switch_A goes down?A . Switch_B(config-if)#ip address 10.10.10.2 255.255.255.0 Switch_B(config-if)#standby 1 priority 200 Switch_B(config-if)#standby 1 preempt Switch_B(config-if)#standby 1 ip 10.10.10.10 Switch_B(config-if)#standby 1 track interface fa...
Question about action of DAI with invalid IP-to-MAC.
Question about action of DAI with invalid IP-to-MAC.A . InterceptB . DropsC . LogD . NAView AnswerAnswer: ABC
