What is the result of the SPAN configuration on a Cisco switch?

Refer to the exhibit. What is the result of the SPAN configuration on a Cisco switch?A . Configure a SPAN session to monitor the received traffic on interface g0/4 only for VLAN 3.B . Configure a SPAN session to monitor the received traffic on interface g0/4 for all VLANs except...

January 4, 2019 No Comments READ MORE +

What are the two ways to configure loop guard?

What are the two ways to configure loop guard?A . (config)# spanning-tree loopguard defaultB . (config-if)# spanning-tree guard loopC . (config)# spanning-tree loopguard enableD . (config-if)# spanning-tree loopguard defaultE . (config)# spanning-tree guard loopView AnswerAnswer: AB

January 4, 2019 No Comments READ MORE +

Which statement about the use of PAgP link aggregation on a Cisco switch that is running Cisco IOS Software is true?

Which statement about the use of PAgP link aggregation on a Cisco switch that is running Cisco IOS Software is true?A . PAgP modes are off, auto, desirable, and on. Only the combinations auto-desirable, desirable-desirable, and on-on allow the formation of a channel.B . PAgP modes are active, desirable, and...

January 4, 2019 No Comments READ MORE +

Which two statements are true about StackWise? (Choose two.)

Which two statements are true about StackWise? (Choose two.)A . It looks like one device.B . It can use one IP address.C . It can use multiple IP address.D . It looks like a multiple device.E . StackWise manages like a hybrid device.View AnswerAnswer: AB

January 3, 2019 No Comments READ MORE +

What would happen if we delete VLAN that exit on switchport?

What would happen if we delete VLAN that exit on switchport?A . Port down and use native VLAC . Port down and use default VLAE . Port up and use native VLAG . Port up and use default VLA . Port will remain shutdown/inactive until it is assigned a new...

January 2, 2019 No Comments READ MORE +

Which two effects of this configuration are true?

Refer to the exhibit. Which two effects of this configuration are true? (Choose two.)A . R1 becomes the active router.B . If R2 goes down, R1 becomes active but reverts to standby when R2 comes back onlineC . Hello messages are sent to multicast address 224.0.0.5.D . If R1 goes...

January 1, 2019 No Comments READ MORE +

There was exhibit for RSPAN with two sessions.

There was exhibit for RSPAN with two sessions.A . session one had destination port was missingB . session two was properly configuredView AnswerAnswer: A

January 1, 2019 No Comments READ MORE +

Which normal VLAN range are valid and is stored in the vlan.dat configuration file?

Which normal VLAN range are valid and is stored in the vlan.dat configuration file?A . VLANs 1-1005B . VLANs 1005-2030C . VLANs 2094-4094D . VLANs 4094-8030View AnswerAnswer: A

January 1, 2019 No Comments READ MORE +

Question about how to disable cdp. (Choose two)

Question about how to disable cdp. (Choose two)A . (config) no cdp runB . (config) cdp disableC . (config-if) no cdp enableD . (config-if) no cdp runE . (config-if) cdp disableF . (config) no cdp enableView AnswerAnswer: AC

January 1, 2019 No Comments READ MORE +

Which statement about using native VLANs to carry untagged frames is true?

Which statement about using native VLANs to carry untagged frames is true?A . Cisco Discovery Protocol version 2 carries native VLAN information, but version 1 does not.B . Cisco Discovery Protocol version 1 carries native VLAN information, but version 2 does not.C . Cisco Discovery Protocol version 1 and version...

December 30, 2018 No Comments READ MORE +