300-101 exam

What does the following access list, which is applied on the external interface FastEthernet 1/0 of the perimeter router, accomplish? router(config)#access-list 101 deny ip 10.0.0.0 0.255.255.255 any log router (config)#access-list 101 deny ip 192.168.0.0 0.0.255.255 any log router (config)#access-list 101 deny ip 172.16.0.0 0.15.255.255 any log router (config)#access-list 101 permit...

Which address is used by the Unicast Reverse Path Forwarding protocol to validate a packet against the routing table?A . source addressB . destination addressC . router interfaceD . default gatewayView AnswerAnswer: A Explanation: The Unicast RPF feature helps to mitigate problems that are caused by the introduction of malformed...

What does the following access list, which is applied on the external interface FastEthernet 1/0 of the perimeter router, accomplish? router(config)#access-list 101 deny ip 10.0.0.0 0.255.255.255 any log router (config)#access-list 101 deny ip 192.168.0.0 0.0.255.255 any log router (config)#access-list 101 deny ip 172.16.0.0 0.15.255.255 any log router (config)#access-list 101 permit...

Refer to the exhibit. Based on this FIB table, which statement is correct?A . There is no default gateway.B . The IP address of the router on FastEthernet is 209.168.201.1.C . The gateway of last resort is 192.168.201.1D . The router will listen for all multicast traffic.View AnswerAnswer: C Explanation:...

What does the following access list, which is applied on the external interface FastEthernet 1/0 of the perimeter router, accomplish? router(config)#access-list 101 deny ip 10.0.0.0 0.255.255.255 any log router (config)#access-list 101 deny ip 192.168.0.0 0.0.255.255 any log router (config)#access-list 101 deny ip 172.16.0.0 0.15.255.255 any log router (config)#access-list 101 permit...

An engineer is asked to monitor the availability of the next-hop IP address of 172.16.201.25 every 3 seconds using an ICMP echo packet via an ICMP echo probe. Which two commands accomplish this task? (Choose two.)A . router(config-ip-sla)#icmp-echo 172.16.201.25 source-interface FastEthernet 0/0B . router(config-ip-sla-echo)#timeout 3C . router(config-ip-sla)#icmp-jitter 172.16.201.25 interval 100D...

Refer to the exhibit. Which statement about the command output is true?A . The router exports flow information to 10.10.10.1 on UDP port 5127.B . The router receives flow information from 10.10.10.2 on UDP port 5127C . The router exports flow information to 10.10.10.1 on TCP port 5127D . The...

Refer to the exhibit. The network setup is running the RIP routing protocol. Which two events will occur following link failure between R2 and R3? (Choose two.)A . R2 will advertise network 192.168.2.0/27 with a hop count of 16 to R1.B . R2 will not send any advertisements and will...

What is the result of the command ip flow-export destination 10.10.10.1 5858?A . It configures the router to export cache flow information to IP 10.10.10.1 on port UDP/5858.B . It configures the router to export cache flow information about flows with destination IP 10.10.10.1 and port UDP/5858.C . It configures...

Refer to the exhibit. Which statement about the configuration is true?A . 20 packets are being sent every 30 seconds.B . The monitor starts at 12:05:00 a.m.C . Jitter is being tested with TCP packets to port 65051D . The packets that are being sent use DSCP EView AnswerAnswer: A