- All Exams Instant Download
A network engineer in the GUI of WCS version 7 wants to add an autonomous access point. Where can this command be found in the drop-down menu?
A network engineer in the GUI of WCS version 7 wants to add an autonomous access point. Where can this command be found in the drop-down menu?A . Configure > Access Point > Add Autonomous APsB . Manage > Access Points > Add Autonomous APsC . Administration > Access Point...
A client is deploying lightweight APs. Those with LAN connections to the controller would be considered what mode of deployment, while access points deployed across a higher latency connection are deployed in what mode?
A client is deploying lightweight APs. Those with LAN connections to the controller would be considered what mode of deployment, while access points deployed across a higher latency connection are deployed in what mode?A . HREAP; BridgeB . Local; BridgeC . HREAP; Flex ConnectD . Local; Flex ConnectView AnswerAnswer: D
In version 8.0 code for CUWN, what interface can be assigned an IPv6 address?
In version 8.0 code for CUWN, what interface can be assigned an IPv6 address?A . managementB . dynamicC . AP-managerD . virtualE . service-portView AnswerAnswer: A
On witch tab on the WLC web interface can the administrator change the AP power level?
On witch tab on the WLC web interface can the administrator change the AP power level?A . WLANB . ManagementC . ControllerD . WirelessView AnswerAnswer: D
Which EtherChannel mode should be used on the switch to allow for the WLC to connect?
A customer has asked for the proper port configuration to allow for LAG on a Cisco 2504 Wireless Controller to a Cisco IOS switch. Which EtherChannel mode should be used on the switch to allow for the WLC to connect?A . onB . autoC . desirableD . passiveE . activeView...
What is the reason for this?
An engineer has been noticing the power settings on several of the office APs change from day to day ever since two more APs were installed. After logging into the WLC, the engineer verifies that the power levels on 4 of the 802.11n radios are fluctuating up and down. What...
Which three elements define the 802.11n implementation of MIMO?
The IEEE 802.11n standard provides 40-MHz channels, improved MAC efficiency, and MIMO. Which three elements define the 802.11n implementation of MIMO? (Choose three.)A . channel bondingB . dynamic frequency selectionC . maximal ratio combiningD . packet aggregationE . spatial multiplexingF . transmit beam formingView AnswerAnswer: C, E, F
Which report includes this information?
The administrator needs to create a report that shows all controllers, APs, and Cisco 3300 Series MSEs in the WLAN, including hardware and software information. Which report includes this information?A . Device > InventoryB . Mesh > NodesC . Network Summary > Executive SummaryD . Network Summary > 802.11 SummaryView...
What is the IEEE name for a group of access points that are connected by using the Ethernet?
What is the IEEE name for a group of access points that are connected by using the Ethernet?A . ESSB . BSSC . IBSSD . ISSView AnswerAnswer: A
Which menu leads to the Audit Status Report?
Refer to the exhibit. Cisco WCS version 7.0 has a configuration mismatch with what is actually running in the controller. Which menu leads to the Audit Status Report?A . SecurityB . MonitorC . ConfigureD . ServicesE . AdministrationF . ToolsView AnswerAnswer: C
