200-301 exam

Which mode allows access points to be managed by Cisco Wireless LAN Controllers?A . bridgeB . lightweightC . mobility expressD . autonomousView AnswerAnswer: B

Which two conditions must be met before SSH can operate normally on a Cisco IOS switch? (Choose two.)A . IP routing must be enabled on the switch.B . A console password must be configured on the switch.C . Telnet must be disabled on the switch.D . The switch must be...

DRAG DROP Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right. View AnswerAnswer:

Which command automatically generates an IPv6 address from a specified IPv6 prefix and MAC address of an interface?A . ipv6 address dhcpB . ipv6 address 2001:DB8:5:112::/64 eui-64C . ipv6 address autoconfigD . ipv6 address 2001:DB8:5:112::2/64 link-localView AnswerAnswer: C

DRAG DROP Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right. View AnswerAnswer:

DRAG DROP Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right. View AnswerAnswer:

What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two.)A . when Carrier Sense Multiple Access/Collision Detection is usedB . when one side of the connection is configured for half-duplexC . when the sending device waits 15 seconds before sending the frame againD ....

Refer to the exhibit. Which password must an engineer use to enter the enable mode?A . adminadmin123B . cisco123C . defaultD . testing1234View AnswerAnswer: D

What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?A . The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table.B . The Layer 2 switch sends a copy of a...

Refer to the exhibit. Which command provides this output?A . show ip routeB . show cdp neighborC . show ip interfaceD . show interfaceView AnswerAnswer: B