In which way does a spine-and-leaf architecture allow for scalability in a network when additional access ports are required?

In which way does a spine-and-leaf architecture allow for scalability in a network when additional access ports are required?A . A spine switch and a leaf switch can be added with redundant connections between them.B . A spine switch can be added with at least 40 GB uplinks.C . A...

March 24, 2020 No Comments READ MORE +

Which statement explains the configuration error message that is received?

Refer to the exhibit. Which statement explains the configuration error message that is received?A . It belongs to a private IP address range.B . The router does not support /28 mask.C . It is a network IP address.D . It is a broadcast IP address.View AnswerAnswer: D

March 24, 2020 No Comments READ MORE +

Which statement identifies the functionality of virtual machines?

Which statement identifies the functionality of virtual machines?A . The hypervisor communicates on Layer 3 without the need for additional resources.B . Each hypervisor can support a single virtual machine and a single software switch.C . The hypervisor can virtual physical components including CPU, memory, and storage.D . Virtualized servers...

March 24, 2020 No Comments READ MORE +

How does SW2 interact with other switches in this VTP domain?

Refer to the exhibit. How does SW2 interact with other switches in this VTP domain?A . It transmits and processes VTP updates from any VTP clients on the network on its trunk ports.B . It processes VTP updates from any VTP clients on the network on its access ports.C ....

March 24, 2020 No Comments READ MORE +

Which network allows devices to communicate without the need to access the Internet?

Which network allows devices to communicate without the need to access the Internet?A . 172.9.0.0/16B . 172.28.0.0/16C . 192.0.0.0/8D . 209.165.201.0/24View AnswerAnswer: B

March 22, 2020 No Comments READ MORE +

Which two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN Controller GUI? (Choose two.)

Which two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN Controller GUI? (Choose two.)A . QoS settingsB . IP address of one or more access pointsC . SSIDD . profile nameE . management interface settingsView AnswerAnswer: CD

March 21, 2020 No Comments READ MORE +

Which statement about Link Aggregation when implementing on a Cisco Wireless LAN Controller is true?

Which statement about Link Aggregation when implementing on a Cisco Wireless LAN Controller is true?A . The EtherChannel must be configured in “mode active”.B . When enabled, the WLC bandwidth drops to 500 Mbps.C . To pass client traffic, two or more ports must be configured.D . One functional physical...

March 21, 2020 No Comments READ MORE +

What is the result of this configuration?

Two switches are connected and using Cisco Dynamic Trunking Protocol. SW1 is set to Dynamic Auto and SW2 is set to Dynamic Desirable. What is the result of this configuration?A . The link becomes an access port.B . The link is in an error disabled state.C . The link is...

March 21, 2020 No Comments READ MORE +

Which IPv6 address type communication between subnets and cannot route on the Internet?

Which IPv6 address type communication between subnets and cannot route on the Internet?A . link-localB . unique localC . multicastD . global unicastView AnswerAnswer: B

March 20, 2020 No Comments READ MORE +

Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?

Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?A . activeB . onC . autoD . desirableView AnswerAnswer: B

March 20, 2020 No Comments READ MORE +