- All Exams Instant Download
Which password must an engineer use to enter the enable mode?
Refer to the exhibit. Which password must an engineer use to enter the enable mode?A . adminadmin123B . cisco123C . defaultD . testing1234View AnswerAnswer: D
What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?
What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?A . The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table.B . The Layer 2 switch sends a copy of a...
Which command provides this output?
Refer to the exhibit. Which command provides this output?A . show ip routeB . show cdp neighborC . show ip interfaceD . show interfaceView AnswerAnswer: B
Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right
DRAG DROP Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right. View AnswerAnswer:
Which IPv6 address block sends packets to a group address rather than a single address?
Which IPv6 address block sends packets to a group address rather than a single address?A . 2000::/3B . FC00::/7C . FE80::/10D . FF00::/8View AnswerAnswer: D
Which command provides this output?
Refer to the exhibit. Which command provides this output?A . show ip routeB . show cdp neighborC . show ip interfaceD . show interfaceView AnswerAnswer: B
Based on the LACP neighbor status, in which mode is the SW1 port channel configured?
Refer to the exhibit. Based on the LACP neighbor status, in which mode is the SW1 port channel configured?A . mode onB . activeC . passiveD . autoView AnswerAnswer: B
Which two interface counters are incremented?
A frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented? (Choose two.)A . input errorsB . frameC . giantsD . CRCE . runtsView AnswerAnswer: AD
Which prefix does Router1 use to Host A?
Refer to the exhibit. Which prefix does Router1 use to Host A?A . 10.10.10.0/28B . 10.10.13.0/25C . 10.10.13.144/28D . 10.10.13.208/29View AnswerAnswer: D
Based on the output for switch 1, which error must be corrected?
Refer to the exhibit. After the switch configuration, the ping test fails between PC A and PC B. Based on the output for switch 1, which error must be corrected?A . The PCs are in the incorrect VLAC . All VLANs are not enabled on the trunk.D . Access mode...
