- All Exams Instant Download
What is the primary effect of the spanning-tree portfast command?
What is the primary effect of the spanning-tree portfast command?A . It immediately enables the port in the listening state.B . It immediately puts the port into the forwarding state when the switch is reloaded.C . It enabled BPDU messages.D . It minimizes spanning-tree convergence time.View AnswerAnswer: D Explanation: Reference:...
Which unified access point mode continues to serve wireless clients after losing connectivity to the Cisco Wireless LAN Controller?
Which unified access point mode continues to serve wireless clients after losing connectivity to the Cisco Wireless LAN Controller?A . localB . meshC . flexconnectD . snifferView AnswerAnswer: C Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/ flexconnect.html
What is a benefit of using a Cisco Wireless LAN Controller?
What is a benefit of using a Cisco Wireless LAN Controller?A . It eliminates the need to configure each access point individually.B . Central AP management requires more complex configurations.C . Unique SSIDs cannot use the same authentication method.D . It supports autonomous and lightweight APs.View AnswerAnswer: A
Which IPv6 address block sends packets to a group address rather than a single address?
Which IPv6 address block sends packets to a group address rather than a single address?A . 2000::/3B . FC00::/7C . FE80::/10D . FF00::/8View AnswerAnswer: D
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?A . activeB . onC . autoD . desirableView AnswerAnswer: B
When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two.)
When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two.)A . 2000::/3B . 2002::5C . FC00::/7D . FF02::1E . FF02::2View AnswerAnswer: DE Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipv6/configuration/xe-3s/ipv6-xe-36s-book/ip6multicast.html
Which action is taken by the phone?
A Cisco IP phone receives untagged data traffic from an attached PC. Which action is taken by the phone?A . It drops the traffic.B . It allows the traffic to pass through unchanged.C . It tags the traffic with the native VLAE . It tags the traffic with the default...
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?A . lldp timerB . lldp tlv-selectC . lldp reinitD . lldp holdtimeView AnswerAnswer: C Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_37_ey/ configuration/guide/scg/swlldp.pdf
Which action do the switches take on the trunk link?
Refer to the exhibit. Which action do the switches take on the trunk link?A . The trunk does not form, and the ports go into an err-disabled status.B . The trunk forms, but the mismatched native VLANs are merged into a single broadcast domain.C . The trunk forms, but VLAN...
Refer to the exhibit
DRAG DROP Refer to the exhibit. Drag and drop the networking parameters from the left onto the correct values on the right. View AnswerAnswer:
