- All Exams Instant Download
Which two conditions must be met before SSH can operate normally on a Cisco IOS switch? (Choose two.)
Which two conditions must be met before SSH can operate normally on a Cisco IOS switch? (Choose two.)A . IP routing must be enabled on the switch.B . A console password must be configured on the switch.C . Telnet must be disabled on the switch.D . The switch must be...
Which command provides this output?
Refer to the exhibit. Which command provides this output?A . show ip routeB . show cdp neighborC . show ip interfaceD . show interfaceView AnswerAnswer: B
Which statement explains the configuration error message that is received?
Refer to the exhibit. Which statement explains the configuration error message that is received?A . It belongs to a private IP address range.B . The router does not support /28 mask.C . It is a network IP address.D . It is a broadcast IP address.View AnswerAnswer: D
Which design element is a best practice when deploying an 802.11b wireless infrastructure?
Which design element is a best practice when deploying an 802.11b wireless infrastructure?A . allocating nonoverlapping channels to access points that are in close physical proximity to one anotherB . disabling TCP so that access points can negotiate signal levels with their attached wireless devicesC . configuring access points to...
Which two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN Controller GUI? (Choose two.)
Which two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN Controller GUI? (Choose two.)A . QoS settingsB . IP address of one or more access pointsC . SSIDD . profile nameE . management interface settingsView AnswerAnswer: CD
Which usable IP address and subnet mask combination meets this criteria?
An engineer must configure a /30 subnet between two routes. Which usable IP address and subnet mask combination meets this criteria?A . interface e0/0 description to HQ-A370:42018 ip address 10.2.1.3 255.255.255.252B . interface e0/0 description to HQ-A370:42018 ip address 192.168.1.1 255.255.255.248C . interface e0/0 description to HQ-A370:42018 ip address 172.16.1.4...
Which action is taken by switch port enabled for PoE power classification override?
Which action is taken by switch port enabled for PoE power classification override?A . If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled.B . When a powered device begins drawing power from a PoE switch port, a syslog message is generated.C ....
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?A . lldp timerB . lldp tlv-selectC . lldp reinitD . lldp holdtimeView AnswerAnswer: C Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_37_ey/configuration/guide/scg/swlldp.pdf
What is a characteristic of spine-and-leaf architecture?
What is a characteristic of spine-and-leaf architecture?A . Each link between leaf switches allows for higher bandwidth.B . It provides greater predictability on STP blocked ports.C . It provides variable latency.D . Each device is separated by the same number of hops.View AnswerAnswer: D
Which IPv6 address block forwards packets to a multicast address rather than a unicast address?
Which IPv6 address block forwards packets to a multicast address rather than a unicast address?A . 2000::/3B . FC00::/7C . FE80::/10D . FF00::/12View AnswerAnswer: D
