- All Exams Instant Download
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?A . lldp timerB . lldp tlv-selectC . lldp reinitD . lldp holdtimeView AnswerAnswer: C Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_37_ey/configuration/guide/scg/swlldp.pdf
What is a characteristic of spine-and-leaf architecture?
What is a characteristic of spine-and-leaf architecture?A . Each link between leaf switches allows for higher bandwidth.B . It provides greater predictability on STP blocked ports.C . It provides variable latency.D . Each device is separated by the same number of hops.View AnswerAnswer: D
Which IPv6 address block forwards packets to a multicast address rather than a unicast address?
Which IPv6 address block forwards packets to a multicast address rather than a unicast address?A . 2000::/3B . FC00::/7C . FE80::/10D . FF00::/12View AnswerAnswer: D
Which two command sequences must be configured on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two.)
Which two command sequences must be configured on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two.)A . interface GigabitEthernet0/0/1 channel-group 10 mode autoB . interface GigabitEthernet0/0/1 channel-group 10 mode onC . interface port-channel 10 no switchport ip address 172.16.0.1 255.255.255.0D . interface GigabitEthernet0/0/1 channel-group...
What occurs to frames during the process of frame flooding?
What occurs to frames during the process of frame flooding?A . Frames are sent to all ports, including those that are assigned to other VLANs.B . Frames are sent to every port on the switch that has a matching entry in MAC address table.C . Frames are sent to every...
Which unified access point mode continues to serve wireless clients after losing connectivity to the Cisco Wireless LAN Controller?
Which unified access point mode continues to serve wireless clients after losing connectivity to the Cisco Wireless LAN Controller?A . localB . meshC . flexconnectD . snifferView AnswerAnswer: C Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/flexconnect.html
Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right
DRAG DROP Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right. View AnswerAnswer:
What is the primary effect of the spanning-tree portfast command?
What is the primary effect of the spanning-tree portfast command?A . It immediately enables the port in the listening state.B . It immediately puts the port into the forwarding state when the switch is reloaded.C . It enables BPDU messages.D . It minimizes spanning-tree convergence time.View AnswerAnswer: D Explanation: Reference:...
How do TCP and UDP differ in the way that they establish a connection between two endpoints?
How do TCP and UDP differ in the way that they establish a connection between two endpoints?A . TCP uses the three-way handshake, and UDP does not guarantee message delivery.B . TCP uses synchronization packets, and UDP uses acknowledgment packets.C . UDP provides reliable message transfer, and TCP is a...
Which prefix does Router1 use for traffic to Host A?
Refer to the exhibit. Which prefix does Router1 use for traffic to Host A?A . 10.10.10.0/28B . 10.10.13.0/25C . 10.10.13.144/28D . 10.10.13.208/29View AnswerAnswer: D
