- All Exams Instant Download
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?A . onB . autoC . activeD . desirableView AnswerAnswer: A
Which API is used in controller-based architectures to interact with edge devices?
Which API is used in controller-based architectures to interact with edge devices?A . overlayB . northboundC . underlayD . southboundView AnswerAnswer: D
Which command prevents passwords from being stored in the configuration as plaintext on a router or switch?
Which command prevents passwords from being stored in the configuration as plaintext on a router or switch?A . enable secretB . service password-encryptionC . username Cisco password encryptD . enable passwordView AnswerAnswer: B
Which function dose the range of private IPv4 addresses perform?
Which function dose the range of private IPv4 addresses perform?A . allow multiple companies to each use the same address without conflictsB . provides a direct connection for hosts from outside of the enterprise networkC . ensues that NAT is not required to reach the internet with private range addressingD...
Which function does an SNMP agent perform?
Which function does an SNMP agent perform?A . It manages routing between Layer 3 devices in a network,B . It coordinates user authentication between a network device and a TACACS+ or RADIUS server.C . It sends information about MIB variables in response to requests from the NME . It requests...
Which two routes dose the router install in the routing table?
Refer to the exhibit. A router received these five routes form different routing information sources. Which two routes dose the router install in the routing table? (choose two)A . iBGP route 10.0.0.0/30B . RIP route 10.0.0.0/30C . EIGRP route 10.0.0.1/32D . OSPF route 10.0.0.0/30E . OSPF route 10.0.0.0/16View AnswerAnswer: CE
Which statement explains the configuration error message that is received?
Refer to the exhibit. Which statement explains the configuration error message that is received?A . it belongs to a private IP address rangeB . the router dose not support /28 maskC . it is a network IP addressD . it is a broadcast IP addressView AnswerAnswer: D
When a site-to-site VPN is used, which protocol is responsible for the transport of user data?
When a site-to-site VPN is used, which protocol is responsible for the transport of user data?A . IKEv2B . IKEv1C . IPsecD . MD5View AnswerAnswer: C
What is a difference between RADIUS and TACACS+?
What is a difference between RADIUS and TACACS+?A . TACACS+ encrypts only password information and RADIUS encrypts the entire payloadB . RADIUS logs all commands that are entered by the administrator, but TACACS+ logs only start, stop, and interim commandsC . RADIUS is most appropriate for dial authentication, but TACACS+...
Which configuration accomplishes this task?
Router R1 must send all traffic without a matching routing-table entry to 192.168.1.1. Which configuration accomplishes this task?A . R1# config t R1(config)# ip routing R1(config)# ip route default-route 192.168.1.1B . R1# config t R1(config)# ip routing R1(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.1C . R1# config t R1(config)# ip routing...
