Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?A . lldp timerB . lldp holdtimeC . lldp reinitD . lldp tlv-selectView AnswerAnswer: C Explanation: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_37_ey/configuration/guide/scg/swlldp.pdf
Which action corrects the configuration issue?
Refer to the exhibit. The default-information originate command is configured under the R1 OSPF configuration. After testing, workstation on VLAN 20 at Site B cannot reach a DNS server on the Internet. Which action corrects the configuration issue?A . Add the default-information originate command on R2B . Add the always...
Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?
Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?A . explicitly assign a link-local addressB . disable the EUI-64 bit processC . enable SLAAC on an interfaceD . configure a stateful DHCPv6 server on...
What is the effect of this configuration?
Refer to the exhibit. What is the effect of this configuration?A . The switch port interface trust state becomes untrustedB . The switch port remains administratively down until the interface is connected to another switchC . Dynamic ARP inspection is disabled because the ARP ACL is missingD . The switch...
what event has occurred if a router sends a notice level message to a syslog server?
what event has occurred if a router sends a notice level message to a syslog server?A . An interface line has changed statusB . An ICMP connection has been builtC . A certificate has expiredD . A TCP connection has been torn downView AnswerAnswer: A
What is the expected behavior for the traffic flow for route 10.10.13.0/25?
Refer to the exhibit. An engineer is bringing up a new circuit to the MPLS provider on the Gi0/1 interface of Router1. The new circuit uses eBGP and teams the route to VLAN25 from the BGP path . What is the expected behavior for the traffic flow for route 10.10.13.0/25?A...
What is an advantage of Cisco DNA Center versus traditional campus device management?
What is an advantage of Cisco DNA Center versus traditional campus device management?A . It supports numerous extensibility options including cross-domain adapters and third-party SDKs.B . It supports high availability for management functions when operating in cluster mode.C . It enables easy auto discovery of network elements m a brownfield...
What are two benefits of network automation? (Choose two)
What are two benefits of network automation? (Choose two)A . reduced operational costsB . reduced hardware footprintC . faster changes with more reliable resultsD . fewer network failuresE . increased network securityView AnswerAnswer: AC
Which two outcomes are predictable behaviors for HSRP? (Choose two)
Which two outcomes are predictable behaviors for HSRP? (Choose two)A . The two routers share a virtual IP address that is used as the default gateway for devices on the LAC . The two routers negotiate one router as the active router and the other as the standby routerD ....
How do traditional campus device management and Cisco DNA Center device management differ in regards to deployment?
How do traditional campus device management and Cisco DNA Center device management differ in regards to deployment?A . Cisco DNA Center device management can be implemented at a lower cost than most traditional campus device management optionsB . Traditional campus device management schemes can typically deploy patches and updates more...