- All Exams Instant Download
The show ip ospf interface command has been executed on R1 How is OSPF configured?
Refer to the exhibit. The show ip ospf interface command has been executed on R1 How is OSPF configured?A . The interface is not participating in OSPFB . A point-to-point network type is configuredC . The default Hello and Dead timers are in useD . There are six OSPF neighbors...
When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?
When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?A . The floating static route must have a higher administrative distance than the primary route so it is used as a backupB . The administrative distance must be higher...
What are two reasons that cause late collisions to increment on an Ethernet interface? (choose two)
What are two reasons that cause late collisions to increment on an Ethernet interface? (choose two)A . when the sending device waits 15 seconds before sending the frame againB . when the cable length limits are exceededC . when one side of the connection is configured for half-duplexD . when...
What are two differences between optical-fiber cabling and copper cabling? (Choose two.)
What are two differences between optical-fiber cabling and copper cabling? (Choose two.)A . Fiber connects to physical interfaces using RJ-45 connections.B . The data can pass through the cladding.C . Light is transmitted through the core of the fiber.D . The glass core component is encased in a cladding.E ....
What is the effect of this configuration?
Refer to the exhibit . What is the effect of this configuration?A . The switch port interface trust state becomes untrustedB . The switch port remains administratively down until the interface is connected to another switchC . Dynamic ARP inspection is disabled because the ARP ACL is missingD . The...
Which feature on the Cisco Wireless LAN Controller when enabled restricts management access from specific networks?
Which feature on the Cisco Wireless LAN Controller when enabled restricts management access from specific networks?A . CPU ACLB . TACACSC . Flex ACLD . RADIUSView AnswerAnswer: A Explanation: Reference: https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/71978-acl-wlc.html
Which two misconfigurations cause this behavior?
While examining excessive traffic on the network, it is noted that all incoming packets on an interface appear to be allowed even though an IPv4 ACL is applied to the interface . Which two misconfigurations cause this behavior? (Choose two)A . The packets fail to match any permit statementB ....
Which command enables a router to become a DHCP client?
Which command enables a router to become a DHCP client?A . ip address dhcpB . ip helper-addressC . ip dhcp poolD . ip dhcp clientView AnswerAnswer: A
How do traditional campus device management and Cisco DNA Center device management differ in regards to deployment?
How do traditional campus device management and Cisco DNA Center device management differ in regards to deployment?A . Cisco DNA Center device management can be implemented at a lower cost than most traditional campus device management optionsB . Traditional campus device management schemes can typically deploy patches and updates more...
Which design element is a best practice when deploying an 802.11b wireless infrastructure?
Which design element is a best practice when deploying an 802.11b wireless infrastructure?A . disabling TPC so that access points can negotiate signal levels with their attached wireless devices.B . setting the maximum data rate to 54 Mbps on the Cisco Wireless LAN ControllerC . allocating non overlapping channels to...
