- All Exams Instant Download
Which value can you modify to configure a specific interface as the preferred forwarding interface?
Which value can you modify to configure a specific interface as the preferred forwarding interface?A . The interface numberB . The port priorityC . The VLAN priorityD . The hello timeView AnswerAnswer: B
Which rule does the DHCP server use when there is an IP address conflict?
Refer to the exhibit. Which rule does the DHCP server use when there is an IP address conflict?A . The address is removed from the pool until the conflict is resolved.B . The address remains in the pool until the conflict is resolved.C . Only the IP detected by Gratuitous...
Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over FastEthernet?
Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over FastEthernet?A . 802.3adB . 802.1wC . 802.1QD . 802.1dView AnswerAnswer: C
Which statement about LLDP is true?
Which statement about LLDP is true?A . It is a Cisco proprietary protocolB . It is configured in global configuration mode.C . The LLDP update frequency is a fixed value.D . It runs over the transport layer.View AnswerAnswer: B
Where does the configuration reside when a helper address is configured to support DHCP?
Where does the configuration reside when a helper address is configured to support DHCP?A . on the switch trunk interface.B . on the router closest to the client.C . on the router closest to the server.D . on every router along the path.View AnswerAnswer: B
What value is primarily used to determine which port becomes the root port on each nonroot switch in a spanning-tree topology?
What value is primarily used to determine which port becomes the root port on each nonroot switch in a spanning-tree topology?A . lowest port MAC addressB . port priority number and MAC address.C . VTP revision numberD . highest port priority number.E . path costView AnswerAnswer: E
Which NTP type designates a router without an external reefrence clock as an authoritative time source?
Which NTP type designates a router without an external reefrence clock as an authoritative time source?A . serverB . peerC . masterD . clientView AnswerAnswer: C
Given the information in the graphic and assuming that the router and switch2 are configured properly, which of the following commands should be issued on switch 1 to correct this problem?
The network administrator cannot to switch 1 over a telnet session, although the hosts attached to switch 1 can ping the interface Fa0/0 of the router. Given the information in the graphic and assuming that the router and switch2 are configured properly, which of the following commands should be issued...
At which layer of the OSI model dose PPP perform?
At which layer of the OSI model dose PPP perform?A . Layer 3B . Layer 4C . Layer 2D . Layer 5View AnswerAnswer: C
A network administrator needs to configure port security on a switch.which two statements are true? (choose two)
A network administrator needs to configure port security on a switch.which two statements are true? (choose two)A . The network administrator can apply port security to dynamic access portsB . The network administrator can configure static secure or sticky secure mac addresses in the voice vlan.C . The sticky learning...
