- All Exams Instant Download
For which two reasons was RFC 1918 address space define (Choose two)
For which two reasons was RFC 1918 address space define (Choose two)A . to preserve public IPv4 address spaceB . to reduce the occurrence of overlapping IP addressesC . to preserve public IPv6 address spaceD . reduce the size of ISP routing tablesE . to support the NAT protocolView AnswerAnswer:...
Which statement about vlan operation on cisco catalyst switches is true?
Which statement about vlan operation on cisco catalyst switches is true?A . when a packet is received from an 802.1Q trunk, the vlan id can be determined from the source MAC address table.B . unkown unicast frames are retransmitted only to the ports that belong to the same vlanC ....
which task must you perform to enable an IOS device to use DNS services?
which task must you perform to enable an IOS device to use DNS services?A . configure a relay agent information reforwarding policyB . configure manual bindingsC . configure the relay agent information optionD . configure a name serverView AnswerAnswer: B
which value indicate the distance from the ntp authoritative time source?
which value indicate the distance from the ntp authoritative time source?A . priorityB . locationC . layerD . stratumView AnswerAnswer: D
Which standards-based First Hop Redundancy Protocol is a Cisco supported alternative to Hot Standby Router Protocol?
Which standards-based First Hop Redundancy Protocol is a Cisco supported alternative to Hot Standby Router Protocol?A . VRRPB . GLBPC . TFTPD . DHCPView AnswerAnswer: A
What set of commands was configured on interface Fa0/3 to produce the given the output?
Refer to the exhibit. What set of commands was configured on interface Fa0/3 to produce the given the output?A . interface FastEthernet 0/3 Channel-group 1 mode desirable Switchport trunk encapsulation dot1q Switchport mode trunkB . interface FastEthernet 0/3 Channel-group 2 mode passive Switchport trunk encapsulation dot1q Switchport mode trunkC ....
What will Switch-1 do with this data?
Refer to the exhibit. Switch-1 needs to send data to a host with a MAC address of 00b0.d056.efa4. What will Switch-1 do with this data?A . switch-1 will drop the data because it dose not have an entry for that MAC addressB . switch-1 will flood the data out all...
When you troubleshoot an IPv4 connectivity issue on a router, which three router configuration checks you must perform? (choose three)
When you troubleshoot an IPv4 connectivity issue on a router, which three router configuration checks you must perform? (choose three)A . Verify that the router interface IP address IP address is correct.B . Verify that the DNS is configured correctly.C . Verify that the router and the host use the...
Which command can you enter to configure an IPV6 floating static route?
Which command can you enter to configure an IPV6 floating static route?A . Router(config)# ipv6 route FE80:0202::/32 serail 0/1 201B . Router(config)# ipv6 route::/0 serail0/1C . Router(config)# ipv6 route static resolve defaultD . Router(config)# ipv6 route FE80:0202::/32 serail 0/1 1View AnswerAnswer: A
How can you disable DTP on a switch port?
How can you disable DTP on a switch port?A . Configure the switch port as a trunk.B . Add an interface on the switch to a channel group.C . Change the operational mode to static accessD . Change the administrative mode to accessView AnswerAnswer: D
