What is the issue?

Refer to the exhibit. The network administrator normally establishes a telnet session with the switch from host A.However, host A is unavailable. The administrator′s attempt to the switch from host B fails, but pings to the other two hosts are successful. What is the issue? A. Host B and the...

March 8, 2020 No Comments READ MORE +

What is the most appropriate summarization for these routes?

Refer to the exhibit. What is the most appropriate summarization for these routes?A . 10.0.0.0 /21B . 10.0.0.0 /22C . 10.0.0.0 /23D . 10.0.0.0 /24View AnswerAnswer: B

March 8, 2020 No Comments READ MORE +

Which two a Layer 3 EtherChannel with an open-standard protocol? (Choose two)

Which two a Layer 3 EtherChannel with an open-standard protocol? (Choose two)A . interface GigabitEthernet0/0/1 channel-group 10 mode onB . interface GigabitEthernet0/0/1 channel-group 10 mode activeC . interface GigabitEthernet0/0/1 channel-group 10 mode autoD . interface port-channel 10 switchport switchport mode trunkE . interface port-channel 10 no switchport ip address 172.16.0.1.255.255.255.0View...

March 8, 2020 No Comments READ MORE +

Which command can you enter to re-enable Cisco Discovery Protocol on a local router after it has been disabled?

Which command can you enter to re-enable Cisco Discovery Protocol on a local router after it has been disabled?A . Router(config-if)#cdp runB . Router(config-if)#cdp enableC . Router(config)#cdp runD . Router(config)#cdp enableView AnswerAnswer: C

March 8, 2020 No Comments READ MORE +

Which command can you enter to set the default route for all traffic to an interface?

Which command can you enter to set the default route for all traffic to an interface?A . router(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1B . router(config)#ip route 0.0.0.0 255.255.255.255 GigabitEthernet0/1C . router(config-router)#default-information originateD . router(config-router)#default-information originate alwaysView AnswerAnswer: A

March 7, 2020 No Comments READ MORE +

Which statement about the configuration is true?

Two hosts are attached to a switch with the default configuration. Which statement about the configuration is true?A . IP routing must be enabled to allow the two hosts to communicate.B . The two hosts are in the same broadcast domain.C . The switch must be configured with a VLAN...

March 7, 2020 No Comments READ MORE +

Which two benefits can you get by stacking cisco switches? (choose Two)

Which two benefits can you get by stacking cisco switches? (choose Two)A . The stack enables any active member to take over as the master switch if the existing master fails.B . Each switch in the stack can use a different IOS imageC . You can add or remove switches...

March 7, 2020 No Comments READ MORE +

Which command can you enter to configure an IPV6 floating static route?

Which command can you enter to configure an IPV6 floating static route?A . Router(config)# ipv6 route FE80:0202::/32 serail 0/1 201B . Router(config)# ipv6 route::/0 serail0/1C . Router(config)# ipv6 route static resolve defaultD . Router(config)# ipv6 route FE80:0202::/32 serail 0/1 1View AnswerAnswer: A

March 7, 2020 No Comments READ MORE +

Which two statements about using leased lines for your WAN infrastructure are true? (Choose two.)

Which two statements about using leased lines for your WAN infrastructure are true? (Choose two.)A . Leased lines provide inexpensive WAN access.B . Leased lines with sufficient bandwidth can avoid latency between endpoints.C . Leased lines require little installation and maintenance expertise.D . Leased lines provide highly flexible bandwidth scaling.E...

March 7, 2020 No Comments READ MORE +

Which function of the IP SLAs ICMP jitter operation can you use to determine whether a VoIP issue is caused by excessive end-to-end time?

Which function of the IP SLAs ICMP jitter operation can you use to determine whether a VoIP issue is caused by excessive end-to-end time?A . packet lossB . jitterC . successive packet lossD . round-trip time latencyView AnswerAnswer: D

March 7, 2020 No Comments READ MORE +