- All Exams Instant Download
If all routers on this network run RIPv2, which configuration should you apply to router R3 to produce this routing table?
Refer to the exhibit. If all routers on this network run RIPv2, which configuration should you apply to router R3 to produce this routing table?A . router rip version 2 network 192.168.3.0 network 192.168.4.0 network192.168.23.0 distance 70 passive-interface defaultB . router rip version 2 network 192.168.3.0 network 192.168.4.0 network192.168.23.0 distance...
Which feature or method can you use to isolate physical layer problems on a serial link?
Which feature or method can you use to isolate physical layer problems on a serial link?A . UDLDB . loopback testsC . protocol analyzerD . autonegotiationView AnswerAnswer: B
Which route or routes will the router install in the routing table?
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which...
If a router has four interfaces and each interface is connected to four switches, how many broadcast domains are present on the router?
If a router has four interfaces and each interface is connected to four switches, how many broadcast domains are present on the router?A . 1B . 2C . 4D . 8View AnswerAnswer: C
Which two TLVs does LLDP support? (Choose two)
Which two TLVs does LLDP support? (Choose two)A . system descriptionB . a spanning treeC . port duplexD . native VLANE . management addressView AnswerAnswer: AE
How should the network administrator configure the serial interface of the main office router to make the connection?
A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?A . Main (config)#interface serial 0/0...
What would be the most effective steps to troubleshoot this physical layer problem?
Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem? (Choose three.)A . Ensure that the Ethernet encapsulations match on the interconnected router and switch ports.B . Ensure that cables...
Which two circumstances can prevent two routers from establishing an EIGRP neighbor adjacency? (Choose two)
Which two circumstances can prevent two routers from establishing an EIGRP neighbor adjacency? (Choose two)A . The routers have mismatched K valuesB . Both routers have the same router IDC . An ACL is blocking traffic from multicast address 224.0.0.5D . The two routers have the same autonomous system number.E...
HostA cannot ping HostB. Assuming routing is properly configured, what is the cause of this problem?
Refer to the exhibit. HostA cannot ping HostB. Assuming routing is properly configured, what is the cause of this problem?A . The serial interfaces of the routers are not on the same subnetB . The Fa0/o interface on RouterB is using a broadcast addressC . The address of SwitchA is...
What is a characteristic of an EMC Avamar NDMP backup?
What is a characteristic of an EMC Avamar NDMP backup?A . After the first level 0 backup, level 1 backups are performed and merged to a full backup.B . Every backup is a level 0 backup.C . Level 1 backups are performed daily and merged to a full backup at...
