- All Exams Instant Download
Which statement about DTP is true?
Which statement about DTP is true?A . It uses the native VLAC . It negotiates a trunk link after VTP has been configured.D . It uses desirable mode by default.E . It sends data on VLAN 1.View AnswerAnswer: A
Which PPP subprotocol negotiates authentication options?
Which PPP subprotocol negotiates authentication options?A . NCPB . ISDNC . SLIPD . LCPE . DLCIView AnswerAnswer: D Explanation: A protocol that establishes, configures, and tests data link connections used by the PPP Link Control Protocol offers PPP encapsulation different options, including the following: Authentication - options includes PAP and...
What does this mean?
The output of the show frame-relay pvc command shows "PVC STATUS = INACTIVE". What does this mean?A . The PVC is configured correctly and is operating normally, but no data packets have been detected for more than five minutes.B . The PVC is configured correctly, is operating normally, and is...
Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement?
Refer to the exhibit. A network associate has configured OSPF with the command: City(config-router)# network 192.168.12.64 0.0.0.63 area 0 After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to...
Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?
Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?A . hop countB . administrative distanceC . link bandwidthD . link delayE . link costView AnswerAnswer: B Explanation: What Is Administrative Distance? http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094195.shtml Administrative distance is...
Which information is provided by the Load value?
Refer to the exhibit. While troubleshooting a switch, you executed the show interface port-channel 1 etherchannel command and it returned this output. Which information is provided by the Load value?A . the percentage of use of the linkB . the preference of the linkC . the session count of the...
How will the router handle a packet destined for 192.0.2.156?
Refer to the exhibit. How will the router handle a packet destined for 192.0.2.156?A . The router will drop the packet.B . The router will return the packet to its source.C . The router will forward the packet via Serial2.D . The router will forward the packet via either Serial0...
How will the default route configured on R1 affect the operation of R2?
Refer to the exhibit. Assume that all router interfaces are operational and correctly configured. In addition, assume that OSPF has been correctly configured on router R2. How will the default route configured on R1 affect the operation of R2?A . Any packet destined for a network that is not directly...
Which two options are valid WAN connectivity methods? (Choose two.)
Which two options are valid WAN connectivity methods? (Choose two.)A . PPPB . WAPC . DSLD . L2TPv3E . EthernetView AnswerAnswer: A, C Explanation: On each WAN connection, data is encapsulated into frames before it crosses the WAN link. The following are typical WAN protocols:
Given the output shown from this Cisco Catalyst 2950, what is the reason that interface FastEthernet 0/10 is not the root port for VLAN 2?
Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the reason that interface FastEthernet 0/10 is not the root port for VLAN 2?A . This switch has more than one interface connected to the root network segment in VLAN 2.B . This switch is...
