- All Exams Instant Download
In GLBP, which router will respond to client ARP requests?
In GLBP, which router will respond to client ARP requests?A . The active virtual gateway will reply with one of four possible virtual MAC addresses.B . All GLBP member routers will reply in round-robin fashion.C . The active virtual gateway will reply with its own hardware MAC address.D . The...
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow? (Choose three.)
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow? (Choose three.)A . source IP addressB . source MAC addressC . egress interfaceD . ingress interfaceE . destination IP addressF . IP next-hopView AnswerAnswer: A, D, E Explanation:...
To allow or prevent load balancing to network 172.16.3.0/24, which of the following commands could be used in R2? (Choose two.)
To allow or prevent load balancing to network 172.16.3.0/24, which of the following commands could be used in R2? (Choose two.) A . R2(config-if)#clock rateB . R2(config-if)#bandwidthC . R2(config-if)#ip ospf costD . R2(config-if)#ip ospf priorityE . R2(config-router)#distance ospfView AnswerAnswer: B, C Explanation: OSPF Cost http://www.cisco.com/en/US/tech/tk365/technologies_white_paper09186a0080094e9e.shtml#t6 The cost (also called metric)...
What Netflow component can be applied to an interface to track IPv4 traffic?
What Netflow component can be applied to an interface to track IPv4 traffic?A . flow monitorB . flow recordC . flow samplerD . flow exporterView AnswerAnswer: A Explanation: A flow monitor is essentially a NetFlow cache. The Flow Monitor has two major components the Flow Record and the Flow Exporter....
What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router?
What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router?A . 2B . 4C . 16D . unlimitedView AnswerAnswer: B Explanation: 4 is the default number of routes that OSPF will include in routing table if more than...
Which statement about switch access ports is true?
Which statement about switch access ports is true?A . They drop packets with 802.1Q tags.B . A VLAN must be assigned to an access port before it is created.C . They can receive traffic from more than one VLAN with no voice supportD . By default, they carry traffic for...
Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?
Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?A . 10.1.1.2B . 10.154.154.1C . 172.16.5.1D . 192.168.5.3View AnswerAnswer: C Explanation: CCNA Tutorial: The OSPF Router ID (RID) http://www.thebryantadvantage.com/CCNACertificationExamTutorialOSPFRouterIDRID.htm When determining the...
Which path does traffic take from R1 to R5?
Scenario Refer to the topology. Your company has connected the routers R1. R2. and R3 with serial links. R2 and R3 are connected to the switches SW1 and SW2, respectively. SW1 and SW2 are also connected to the routers R4 and R5. The EIGRP routing protocol is configured. You are...
Which spanning-tree feature places a port immediately into a forwarding stated?
Which spanning-tree feature places a port immediately into a forwarding stated?A . BPDU guardB . PortFastC . loop guardD . UDLDE . Uplink FastView AnswerAnswer: B Explanation: PortFast causes a switch or trunk port to enter the spanning tree forwarding state immediately, bypassing the listening and learning states. You can...
Which identification number is valid for an extended ACL?
Which identification number is valid for an extended ACL?A . 1B . 64C . 99D . 100E . 299F . 1099View AnswerAnswer: D
