Which two options will help to solve the problem of a network that is suffering a broadcast storm? (Choose two.)

Which two options will help to solve the problem of a network that is suffering a broadcast storm? (Choose two.)A . a bridgeB . a routerC . a hubD . a Layer 3 switchE . an access pointView AnswerAnswer: BD Explanation: Routers and layer 3 switches will not propagate broadcast...

July 25, 2018 No Comments READ MORE +

As packets travel from Mary to Robert, which three devices will use the destination MAC address of the packet to determine a forwarding path?

Refer to the exhibit. As packets travel from Mary to Robert, which three devices will use the destination MAC address of the packet to determine a forwarding path? (Choose three.)A . Hub1B . Switch1C . Router1D . Switch2E . Router2F . Switch3View AnswerAnswer: BDF Explanation: Switches use the destination MAC...

July 25, 2018 No Comments READ MORE +

Which address could be assigned to the FastEthernet interface on RouterA?

Refer to the exhibit. The internetwork is using subnets of the address 192.168.1.0 with a subnet mask of 255.255.255.224. The routing protocol in use is RIP version 1. Which address could be assigned to the FastEthernet interface on RouterA?A . 192.168.1.31B . 192.168.1.64C . 192.168.1.127D . 192.168.1.190E . 192.168.1.192View AnswerAnswer:...

July 25, 2018 No Comments READ MORE +

What are possible reasons for this problem?

Refer to the graphic. R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem? (Choose two)A . All of the routers need to be configured for backbone Area 1B . R1 and R2 are the DR and BDR, so OSPF will not...

July 25, 2018 No Comments READ MORE +

At a minimum, what must the administrator do to enable CDP to exchange information between R1 and R2?

Refer to the exhibit. The two routers have had their startup configurations cleared and have been restarted. At a minimum, what must the administrator do to enable CDP to exchange information between R1 and R2?A . Configure the router with the cdp enable command.B . Enter no shutdown commands on...

July 25, 2018 No Comments READ MORE +

Which router command can be used to determine the status of Serial 0/0?

Which router command can be used to determine the status of Serial 0/0?A . show ip routeB . show interfacesC . show s0/0 statusD . debug s0/0E . show runF . show versionView AnswerAnswer: B

July 24, 2018 No Comments READ MORE +

Which statements describe the routing protocol OSPF? (Choose three)

Which statements describe the routing protocol OSPF? (Choose three)A . It supports VLSC . It is used to route between autonomous systems.D . It confines network instability to one area of the network.E . It increases routing overhead on the network.F . It allows extensive control of routing updates.G ....

July 24, 2018 No Comments READ MORE +

What is the cause of this problem?

Refer to the exhibit. A TFTP server has recently been installed in the Atlanta office. The network administrator is located in the NY office and has made a console connection to the NY router. After establishing the connection they are unable to backup the configuration file and IOS of the...

July 24, 2018 No Comments READ MORE +