- All Exams Instant Download
After the network has converged, what type of messaging, if any, occurs between R3 and R4?
After the network has converged, what type of messaging, if any, occurs between R3 and R4? A . No messages are exchangedB . Hellos are sent every 10 seconds.C . The full database from each router is sent every 30 seconds.D . The routing table from each router is sent...
What are three problems with this design?
168.100.1 through 192.168.100.255 What are three problems with this design? (Choose three.)A . The AREA 1 IP address space is inadequate for the number of users.B . The AREA 3 IP address space is inadequate for the number of users.C . AREA 2 could use a mask of /25 to...
What is the most likely cause of the problem?
Refer to the exhibit. A user cannot reach any web sites on the Internet, but others in the department are not having a problem. What is the most likely cause of the problem?A . IP routing is not enabled.B . The default gateway is not in the same subnet.C ....
Which statement is true about this command?
The command ip route 192.168.100.160 255.255.255.224 192.168.10.2 was issued on a router. No routing protocols or other static routes are configured on the router. Which statement is true about this command?A . The interface with IP address 192.168.10.2 is on this router.B . The command sets a gateway of last...
Based on the results of the testing, what could be the problem?
Refer to the exhibit. A technician is troubleshooting a host connectivity problem. The host is unable to ping a server connected to Switch_A. Based on the results of the testing, what could be the problem? A. A remote physical layer problem exists. B. The host NIC is not functioning. C....
What is the network address for the host with IP address 192.168.23.61/28?
What is the network address for the host with IP address 192.168.23.61/28?A . 192.168.23.0B . 192.168.23.32C . 192.168.23.48D . 192.168.23.56E . 192.168.23.60View AnswerAnswer: C Explanation: convert bit-length prefix to quad-dotted decimal representation, then from it find the number of bits used for subnetting you can find previously calculated number of...
What are possible reasons for this problem?
Refer to the graphic. R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem? (Choose two)A . All of the routers need to be configured for backbone Area 1B . R1 and R2 are the DR and BDR, so OSPF will not...
The ip helper-address command does what?
The ip helper-address command does what?A . assigns an IP address to a hostB . resolves an IP address from a DNS serverC . relays a DHCP request across networksD . resolves an IP address overlapping issueView AnswerAnswer: C Explanation: When the DHCP client sends the DHCP request packet, it...
On a live network, which commands will verify the operational status of router interfaces? (Choose two.)
On a live network, which commands will verify the operational status of router interfaces? (Choose two.)A . Router# show interfacesB . Router# show ip protocolsC . Router# debug interfaceD . Router# show ip interface briefE . Router# show startView AnswerAnswer: AD Explanation: Both these commands will show the current status...
Which network device and interface configuration meets the minimum requirements for this installation?
Refer to the exhibit. A network device needs to be installed in the place of the icon labeled Network Device to accommodate a leased line attachment to the Internet. Which network device and interface configuration meets the minimum requirements for this installation?A . a router with two Ethernet interfacesB ....
