- All Exams Instant Download
What are possible reasons for this problem?
Refer to the graphic. R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem? (Choose two)A . All of the routers need to be configured for backbone Area 1B . R1 and R2 are the DR and BDR, so OSPF will not...
Based on the output shown, what could be the problem?
Refer to the exhibit. An administrator cannot connect from R1 to R2. To troubleshoot this problem, the administrator has entered the command shown in the exhibit. Based on the output shown, what could be the problem?A . The serial interface is configured for half duplex.B . The serial interface does...
Which two of these statements are true of IPv6 address representation? (Choose two.)
Which two of these statements are true of IPv6 address representation? (Choose two.)A . There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.B . A single interface may be assigned multiple IPv6 addresses of any type.C . Every IPv6 interface contains at least one loopback address.D ....
What are possible reasons for this problem?
R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem? (Choose two)A . All of the routers need to be configured for backbone Area 1.B . R1 and R2 are the DR and BDR, so OSPF will not establish neighbor adjacency with...
What is the bandwidth on the WAN interface of Router 1?
What is the bandwidth on the WAN interface of Router 1?A . 16 Kbit/secB . 32 Kbit/secC . 64 Kbit/secD . 128 Kbit/secE . 512 Kbit/secF . 1544 Kbit/secView AnswerAnswer: A Explanation: Use the “show interface s0/0” to see the bandwidth set at 16 Kbit/sec.
From a console connection, what password or password sequence is required for the administrator to access privileged mode on Router1?
Refer to the exhibit. The network administrator made the entries that are shown and then saved the configuration. From a console connection, what password or password sequence is required for the administrator to access privileged mode on Router1?A . ciscoB . sanfranC . sanjoseD . either cisco or sanfranE ....
After the network has converged, what type of messaging, if any, occurs between R3 and R4?
After the network has converged, what type of messaging, if any, occurs between R3 and R4? A . No messages are exchangedB . Hellos are sent every 10 seconds.C . The full database from each router is sent every 30 seconds.D . The routing table from each router is sent...
Which three statements are true about the operation of a full-duplex Ethernet network? (Choose three.)
Which three statements are true about the operation of a full-duplex Ethernet network? (Choose three.)A . There are no collisions in full-duplex mode.B . A dedicated switch port is required for each full-duplex node.C . Ethernet hub ports are preconfigured for full-duplex mode.D . In a full-duplex environment, the host...
What should be done to fix this problem?
Refer to the exhibit. A network administrator has configured a Catalyst 2950 switch for remote management by pasting into the console the configuration commands that are shown in the exhibit. However, a Telnet session cannot be successfully established from a remote host. What should be done to fix this problem?A...
If CDP is enabled on all devices and interfaces, which devices will appear in the output of a show cdp neighbors command issued from R2?
Refer to the exhibit. If CDP is enabled on all devices and interfaces, which devices will appear in the output of a show cdp neighbors command issued from R2?A . R2 and R3B . R1 and R3C . R3 and S2D . R1, S1, S2, and R3E . R1, S1,...
