Referring to the CLI output shown in the exhibit, which statement is correct?

Exhibit

CE-1 must advertise ten subnets to PE-1 using BGP Once CE-1 starts advertising the subnets to PE-1, the BGP peering state changes to Active.

Referring to the CLI output shown in the exhibit, which statement is correct?
A . CE-1 is advertising its entire routing table.
B . CE-1 is configured with an incorrect peer AS
C . The prefix limit has been reached on PE-1
D . CE-1 is unreachable

View Answer

Answer: C

Explanation:

Referring to the CLI output in the exhibit provided and considering the description of the scenario where CE-1 must advertise ten subnets to PE-1 using BGP and the BGP peering state changes to Active, here are the correct statements based on the typical behaviors and configurations in BGP:

The prefix limit has been reached on PE-1. When the BGP peering state changes to Active after the subnets are advertised, it may suggest that the maximum number of prefixes that PE-1 is configured to receive has been reached. This is indicated by the prefix-limit configuration which is set to a maximum of 5, and as CE-1 is required to advertise ten subnets, this limit is exceeded.