- All Exams Instant Download
Which two solutions should be used?
A customer has a primary datacenter with 12 Nutanix blocks distributed across three racks. The customer wants to achieve the most resiliency possible. They also have a datacenter in a branch office that is 400 kilometers away from the primary datacenter. Which two solutions should be used? (Choose two.)A ....
What are two impacts on the cluster?
An administrator responsible for a VDI environment needs to investigate reports of slow logins. The administrator finds that increasing the number of vCPUs from 2 to 4 will reduce the login times. Production workloads are consuming 75% of the host CPU on the cluster. The administrator increases the vCPU count...
What is the effect of simultaneous disk failures on two nodes located in block A?
A Nutanix cluster is deployed with the following configuration: • Three four-node blocks (A, B, and C) • All Flash Redundancy Factor 2 What is the effect of simultaneous disk failures on two nodes located in block A?A . VMs are migrated off of the nodes with disk failures.B ....
What is the recommended configuration change to improve throughput?
An administrator has a custom backup application that requires a 2TB disk and runs in Windows. Throughput is considerably lower than expected. The application was installed on a VM with the following configuration: • Four vCPUs with one core/vCPU • 4GB of Memory • One 50GB vDisk for the Windows...
Which function should be used to revert any settings that have changed from the defaults and prevent further violations?
An administrator learns that some security settings in a cluster have been changed. The environment is out of compliance with required policies. Which function should be used to revert any settings that have changed from the defaults and prevent further violations?A . Cluster Lockdown with strong password enforcementB . Advanced...
Using Prism Central, which steps are required to identify the correct VMs to be deleted?
An administrator needs to initiate a new VDI project within a couple of months. Prism Central reports there are no storage resources to accommodate such workloads. The administrator sees many powered-off VMs and has the authority to delete test VMs powered off at least for 30 days. Test VMs belong...
Why are the guest VMs experiencing high latency?
An administrator receives reports about a Nutanix environment. The investigation finds the following; • VMs are experiencing very high latency • Each node is equipped with a single SSD, utilized at 95% • Each node is equipped with three HDDs, utilized at 40% Why are the guest VMs experiencing high...
Which configuration issue likely caused this outage?
Refer to the exhibit. A Nutanix host is connected as shown in the exhibit with br0-up set to active/backup. Physical Switch 1 experiences a power outage causing br0-up to failover to using eth2. The CVM and host become inaccessible. User VMs restart on other hosts in the cluster, which causes...
Which two actions should the administrator perform to determine if the current cluster can accommodate the new VMs?
A systems administrator needs to add more VMs to their Nutanix cluster. Which two actions should the administrator perform to determine if the current cluster can accommodate the new VMs? (Choose two.)A . Perform an Inventory with Life Cycle Management.B . Determine utilization with Cluster Runway.C . Enable Deduplication and...
What is causing this issue?
An administrator receives an alert in Prism indicating that interface eth2, on an AHV host is receiving many CRC errors. After togging into the problematic host, the following command is run to show the indicated output: What is causing this issue?A . Incorrect link speeds on the switchB . The...
