- All Exams Instant Download
Referring to the exhibit, which statement is correct?
A 2-node cluster hosts only NAS data UFs. Allnodes lose access to the cluster network. Referring to the exhibit, which statement is correct?A . Both nodes race to takeover the other, one node will takeover the other node. B. No takeover event will occur and NAS data UFs will not...
What has happened in this situation?
The motherboard of Node-01 is being replaced. To perform this task, a takeover was Initiated from Node-02. Node-02 panics showing the string below. PANIC; Permanent errors on all HA mailbox disks (while marshalling header) in SKprocess fnmbx_instanceWorker on release 9.5P8 (C) What has happened in this situation?A . While in...
Which FIFO message Is useful for Investigating this Issue?
A system panic due to an "L2 watchdog timeout hard reset" error occurred. You have found a FIFO message in the SP log. Which FIFO message Is useful for Investigating this Issue?A . before NMI BBSP:C=00 L=00 FIFO: F3 F2 F1 F0 5 B2 0 0 0 80 20 E...
In this scenario, which component should you troubleshoot first?
You receive the panic message shown in the exhibit. In this scenario, which component should you troubleshoot first?A . the PCI card in slot 3 B. the MetroCluster FC-Vl card in slot 6 C. the memory module in slot 1 D. the CPUView AnswerAnswer: D
Which two automation methods does NetApp ONTAP Select support? (Choose two.)
Which two automation methods does NetApp ONTAP Select support? (Choose two.)A . REST B. Anslble C. Docker D. PHPView AnswerAnswer: A,B
In this situation, what would be your next step?
You have a customer complaining of long build times from their NetApp ONTAP-based datastores. They provided you packet traces from the controller and client. Analysis of these traces shows an average service response time of 1 ms. QoS outputconfirms the same. The client traces are reporting an average of 15...
How would youaccomplish this task?
You are attempting to connect a NetApp ONTAP cluster to a very complex network that requires LIFs to fail over across subnets. How would youaccomplish this task?A . Configure an equal number of UFs on each subnet. B. Configure VIP LIFs using OSPF. C. Configure VIP LIFs using BGP. D....
In this scenario, which statement is true?
You notice poor performance on your FlexGroup and execute the system node run -node * flexgroup show command for more Information. You notice the "Urge" column has non-zero values. In this scenario, which statement is true?A . The aggregate is completely full. B. The constituent volumes are out ofInodes. C....
In this scenario, what is causing this problem?
After expanding a two-node AFF A300 cluster with two AFF A700 nodes, you observe latencies when data is accessed indirectly. The system node run -node -command netstat command shows retransmits and packet drops on the LIFs. The AFF A700 nodes with 40 Gbps and the AFF A300 connect with 10...
In this scenario, which VMware feature Is supported by ONTAP software to accomplish this task?
You have a new VMware vSphere cluster with ESXI 7.0U2 hosts. The hosts are connected to a 4-node AFF A400 NetApp ONTAP9.8 cluster with FC LUNs. You have a requirement to identify and follow I/Os from each VM on the shared FC LUN-backed datastores for troubleshooting purposes. In this scenario,...
