- All Exams Instant Download
The snapvault snap sched-x command can be used to:
The snapvault snap sched-x command can be used to:A . Schedule full backupsB . Start initial backupsC . Schedule incremental backupsD . Specify platforms that can be backed upView AnswerAnswer: C
Which command allows you to access the other nodes console after a takeover has occurred?
Which command allows you to access the other nodes console after a takeover has occurred?A . toggleB . switchC . partnerD . takeoverView AnswerAnswer: C
Which two supported methods would you use to restore data from a SnapVault for NetBackup Volume?
Which two supported methods would you use to restore data from a SnapVault for NetBackup Volume?A . Use the NetBackup Administration ConsoleB . Use drag-and-drop technologiesC . Use the snapvault restore Data ONTAP commandD . Use the SnapRestore Data ONTAP serviceView AnswerAnswer: A B
You can unlicense the cluster feature only in
You can unlicense the cluster feature only inA . normal, disabledB . normal, enabledC . takeover, disabledD . takeover, enabledView AnswerAnswer: A
Which statement describes the results of the snapmirror resync command?
Which statement describes the results of the snapmirror resync command?A . Resynchronization finds the newest common snapshot shared by the two volumes or qtrees, and removes all newer information on the storage appliance on which the command is run.B . Resynchronization made. cause the loss of all data written to...
What must the administrator validate to resolve this problem?
An administrator enables the NFS protocol on an SVM and creates a volume to be used as a datastore in a VMware environment. After a rescan, the volume is not visible on the ESXi hosts. What must the administrator validate to resolve this problem?A . Export policyB . Name serviceC...
The snapvault update command is only available on the secondary system.
The snapvault update command is only available on the secondary system.A . TrueB . FalseView AnswerAnswer: A
Which SyncMirror command mirrors an existing unmirrored aggregate where Data ONTAP selects the disk drives?
Which SyncMirror command mirrors an existing unmirrored aggregate where Data ONTAP selects the disk drives?A . aggr mirror aggrYB . aggr mirror aggrY-mC . aggr mirror aggrY-d 12@ 144D . aggr mirror aggrY-m 12@ 144View AnswerAnswer: A
Which one of the following /etc/snapmirror.conf entries will not support synchronous SnapMirror?
Which one of the following /etc/snapmirror.conf entries will not support synchronous SnapMirror?A . FilerA:source_vol FilerB: destination_vol- syncB . FilerA: source_vol FilerB: destination_vol outstanding=3s syncC . FilerA: source_vol FilerB: destination_vol-0-55/5***D . FilerA: source_vol FilerB: destination_vol visibility_interval=1hr, outstanding=3ms, cksum=crc32 syncView AnswerAnswer: C
Which two supported methods would you use to restore data from a SnapVaultfor NetBackup Volume?
Which two supported methods would you use to restore data from a SnapVaultfor NetBackup Volume?A . Use the NetBackup Administration ConsoleB . Use drag-and-drop technologiesC . Use the snapvault restore Data ONTAP commandD . Use the SnapRestore Data ONTAP serviceView AnswerAnswer: A B
