Network Appliance NS0-184 NetApp Certified Storage Installation Engineer, ONTAP Online Training
Network Appliance NS0-184 Online Training
The questions for NS0-184 were last updated at Nov 19,2024.
- Exam Code: NS0-184
- Exam Name: NetApp Certified Storage Installation Engineer, ONTAP
- Certification Provider: Network Appliance
- Latest update: Nov 19,2024
Which logical interface has a fixed firewall policy?
- A . data LIF
- B . cluster management LIF
- C . cluster LIF
- D . intercluster LIF
Click the Exhibit button.
What are two functions of the four Ethernet switches in the supported configuration that is shown in the exhibit? (Choose two.)
- A . to provide a direct connection for the SnapMirror Synchronous (SM-S)
- B . to install cross-site cluster management switches
- C . to provide connectivity for NVRAM over iWARP
- D . to enable SyncMirror replication
You have completed a base installation and system registration of an AFF A250 system, but you notice that you have one failed drive. Neither “un-failing” nor reseating the drive helped to repair it. You must ensure proper replacement of the failed drive.
In this scenario, which two actions should you take? (Choose two.)
- A . Ask the customer to open a technical case with NetApp Support.
- B . Ask the customer for a drive with the same capacity and replace it.
- C . Run Active IQ Config Advisor to collect all the logs on the system.
- D . Power off the system until the drive has been replaced.
An administrator issued the cluster setup command and configured a 2-node ONTAP 9.8 cluster.
In this scenario, which tool would the administrator use to validate the configuration?
- A . Active IQ Upgrade Advisor
- B . Interoperability Matrix Tool
- C . NetAppDocs
- D . Active IQ Config Advisor
You are deploying an 8-node AFF A700 by using BES-53248 cluster switches. During the installation, you notice that ports higher than 16 are not coming online. You verify that the additional licenses are installed.
Which two additional steps must be taken to bring the additional ports online? (Choose two.)
- A . Reload the firmware
- B . Reload the RCF file
- C . Re-enable each port
- D . Reload the switch
You installed a new 2-node FAS500f ONTAP 9.8 switchless cluster that serves NAS volumes to both NFSv4.1 and SMB clients. The host operating systems have full flow control enabled on their data ports.
In this scenario, which two flow control settings would you verify? (Choose two.)
- A . Verify that the data network ports have full flow control disabled.
- B . Verify that the cluster network ports have full flow control enabled.
- C . Verify that the data network ports have full flow control enabled.
- D . Verify that the cluster network ports have full flow control disabled.
You are installing an AFF A700 system with two disk shelves using ADPv2. After setting up the cluster, you realize that one drive shelf was powered off and that the drives have not been assigned to any of the nodes.
In this scenario, which two resources will help you find a solution? (Choose two.)
- A . Active IQ Config Advisor
- B . NetApp Documentation Center
- C . NetApp Knowledge Base
- D . Active IQ Digital Advisor
You are preparing to add a 2-node AFF A250 system to an existing 4-node AFF A800 cluster with Cisco Nexus 3232C switches. The cluster switches are currently running the Cluster-HA RCF.
In this scenario, which two steps are required to install the AFF A250 system? (Choose two.)
- A . Load the Storage RCF.
- B . Cable the AFF A250 nodes to the next free ports on the switch.
- C . Cable the AFF A250 nodes to the breakout ports on the switch.
- D . Load the Cluster-HA-Breakout RCF.
You are expanding an existing 4-node ONTAP 9.8 cluster with a FAS8300 HA pair by adding a new FAS500f HA pair. Before the expansion, you are asked to save the configuration of the cluster to a backup file.
In this scenario, which two ONTAP configuration backup methods are available? (Choose two.)
- A . storage VM
- B . node
- C . cluster
- D . switch
You have added two new AFF A250 nodes to an existing 4-node cluster with NetApp CN1610 cluster network switches. Although the nodes can join the cluster, the storage failover show command output shows that the NVRAM log is not synchronized, and it cannot reach the partner over an HA interconnect.
In this scenario, which two statements are true? (Choose two.)
- A . The AFF A250 requires switches with 40GbE port support.
- B . The AFF A250 uses different ports for the cluster and the HA interconnect.
- C . The AFF A250 requires switches with 25GbE port support.
- D . The AFF A250 uses the same port for the cluster and the HA interconnect.
Latest NS0-184 Dumps Valid Version with 60 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
