NACE NACE-CIP2-001 Coating Inspector Level 2 Online Training
NACE NACE-CIP2-001 Online Training
The questions for NACE-CIP2-001 were last updated at Nov 19,2024.
- Exam Code: NACE-CIP2-001
- Exam Name: Coating Inspector Level 2
- Certification Provider: NACE
- Latest update: Nov 19,2024
Centrifugal blast cleaning requires:
- A . A large volume of air to propel the abrasive
- B . Very large nozzles
- C . Well maintained blast wheels
- D . The use of single use abrasives
The standards defining surface cleanliness achieved by centrifugal blast cleaning are:
- A . Different than air blast cleaning
- B . The same as air blast cleaning
- C . Slightly different to air blast cleaning
- D . Comparable to air blast cleaning
You are NACE Level 2 Inspector working on a tank lining job where a mobile centrifugal blast unit is being used to blast the tank floor to a NACE No.1/SSPC SP 5. The Contractor has completed his final blast and has called for a hold point inspection. This is the 1 st time you have seen field based centrifugal blast cleaning. You observe what appears to be staining on the substrate however the Contractor assures you this is normal when using centrifugal blast units and what you are seeing is what is defined in the standard as an acceptable variation in appearance.
Your FIRST preferred course of action is to:
- A . Request that the Contractor re-blast the floor
- B . Review the standard with the Contractor and re-inspect the floor
- C . Shut the job down
- D . Call your supervisor
You are a NACE Level 2 in-house inspector working in a shop. Your in-house requires you to perform a sleeve test to test for soluble salts; however the 3 rd party NACE Level 3 inspector, the owner, has a san smart meter and has achieved a very different result and has rejected the pre-cleaning.
Your FIRST course of action is to:
- A . Advise the other inspector he is using an incorrect method
- B . Redo the pre-cleaning based on the other inspectors results
- C . Review the specification with the other inspector to see what method was specified
- D . Advise your QC Manager to change the ITP to the use of the salt smart meter
Surface preparation of concrete is performed using:
- A . Methods that are exactly the same as steel
- B . Methods that are completely different to steel
- C . Methods that have been modified for concrete
- D . Methods that are the same as wood
NACE No.13/ SSPC 6 identifies the use of:
- A . Abrasive blasting only
- B . Watterjetting only
- C . Steam cleaning only
- D . Various methods of cleaning
Differences in technique for abrasive blasting concrete versus steel require the operator to:
- A . Lower the blast pressure
- B . Move the nozzle quicker
- C . Increase the standoff distance
- D . a), b) and c)
The Concrete Repair Institute’s comparators can be used to assess:
- A . Surface cleanliness prior to coating
- B . Surface profile prior to coating
- C . Contamination levels prior to coating
- D . Compressive and tensile strength prior to coating
Surface preparation methods for Non-ferrous metals are:
- A . The same as for Ferrous metals
- B . The same for all Non-FetT0us metals
- C . Specific for each type of Non-ferrous metal
- D . Not required
A single component water borne acrylic coating cures by:
- A . Solvent Evaporation
- B . Coalescence
- C . Co-Reaction
- D . Oxidation
Latest NACE-CIP2-001 Dumps Valid Version with 100 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
