NACE NACE-CIP1-001 Coating Inspector Level 1 Online Training
NACE NACE-CIP1-001 Online Training
The questions for NACE-CIP1-001 were last updated at Nov 20,2024.
- Exam Code: NACE-CIP1-001
- Exam Name: Coating Inspector Level 1
- Certification Provider: NACE
- Latest update: Nov 20,2024
Which of these tests uses a syringe?
- A . Sleeve test
- B . Potassium ferricyanide
- C . Bresle patch
- D . Soluble salts meter
Which one of these elements is not necessary for corrosion to occur:
- A . Anode
- B . Cathode
- C . Reference Cell
- D . Electrolyte
Digital hygrometers
- A . consist of a bimetallic sensing element protected from wind gusts.
- B . are used to measure temperature from a distance.
- C . use a thermocouple in contact with the surface to measure temperature
- D . determine relative humidity, air temperature, and dew point temperature:
Using SSPC Vis 1 as a guide when performing a visual inspection of a steel surface prior to surface preparation a NACE Inspector would assign which designations to the surface condition:
- A . Rust Grades A-D
- B . Surface Conditions E-G
- C . Rust Grades 1-4
- D . Surface Condition H
Inspector’s daily reports are used:
Select All That Apply
- A . By the contractor to estimate the amount of work done that day
- B . To provide continuity between inspectors
- C . To aid in arbitration between the contractor and client
- D . To help in cases of a coating failure
Silicone coatings are typically:
- A . Used strictly in immersion service
- B . Applied in very thick films
- C . Used as a sacrificial primer
- D . Applied in very’ thin films
Excess moisture during holiday testing can cause erroneous indications by creating a path across the surface of the coating to pinholes previously detected, or directly to the signal return connection.
This is often referred to as:
- A . telegraphing.
- B . monitoring
- C . juxtaposing.
- D . transitioning.
ASTM Standards are applicable:
- A . In the USA
- B . In North America
- C . In Asia
- D . When specified
The main responsibilities of the inspector are to
- A . demonstrate to the contractor how to apply the coating.
- B . observe and direct the work of the contractors.
- C . direct and perform the work stated in the specification.
- D . observe and report the quality of the work performed.
When using a sling physchrometer a very large difference between the wet and dry bulb readings indicates:
- A . High Relative Humidity
- B . Low Relative Humidity
- C . High Surface Temperature
- D . Low Surface Temperature
Latest NACE-CIP1-001 Dumps Valid Version with 100 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
If you haven’t done the practical training, then you have to do it and pass the practical exam. Then you will take a (Computer Base Training)written exam online after. Once you pass this two stages, then you will get Certification, and a license to do inspection.
what more do I need to do to get nace level 1 inspector certification once I pass the online study and test? is there some other testing facility I will have to attend or am I immediately eligible to hire out and begin inspecting?