AZ-220 V1

You need to design a module deployment strategy that meets the device requirements. What should you create?A . a single deployment B. a standard deployment for each type of device C. a layered deployment for each type of device D. a single layered deploymentView AnswerAnswer: C

HOTSPOT You need to configure loT module routing to meet the device requirements. How should you complete the route? To answer, select the appropriate options in the answer area. NOTE: Each correct selection is worth one point. View AnswerAnswer:

What should you do to identify the cause of the connectivity issues?A . Send cloud-to-device messages to the IoT devices. B. Use the heartbeat pattern to send messages from the IoT devices to iothub1. C. Monitor the connection status of the device twin by using an Azure function. D. Enable...

Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, while others might not have a correct solution. After you...

HOTSPOT You have an Azure subscription that contains an Azure IoT hub and two IoT devices named Device1 and Device2. You plan to deploy an Azure IoT Edge gateway device named Gateway1. You need to ensure that all device-to-cloud messages and twin change notifications from Device1 and Device2 to the...

You have an Azure subscription that contains the resources shown in the following table. You create a group enrollment in DPS1 and enroll 100 loT devices. Each device is issued a leaf certificate from CAT. You need to deprovision a single loT device from the group enrollment. The solution must...

During the POV phase, telemetry from IoT Hub stops flowing to the hot path. The cold path continues to work. What should you do to restore the hot path?A . Disable the fallback route. B. Run the Test all routes action. C. Create an explicit route for the hot path....

You need to visualize Azure IoT Hub telemetry data by using Microsoft Power BI. Which service should you connect to the IoT hub?A . Azure Event Grid B. SendGrid C. Azure Stream Analytics D. Azure Notification HubsView AnswerAnswer: C Explanation: You can use Microsoft Power BI to visualize real-time sensor...

You have an Azure IoT Central application. You add an IoT device named Oven1 to the application. Oven1 uses an IoT Central template for industrial ovens. You need to send an email to the managers group at your company as soon as the oven temperature falls below 400 degrees. Which...

What should you do to identify the cause of the connectivity issues?A . Send cloud-to-device messages to the IoT devices. B. Use the heartbeat pattern to send messages from the IoT devices to iothub1. C. Monitor the connection status of the device twin by using an Azure function. D. Enable...