Which three actions are necessary to allow the AP to connect to a controller?

You are on the phone working with a colleague that is console connected to a lightweight AP that has lost its configuration. Which three actions are necessary to allow the AP to connect to a controller? (Choose three.)A . Configure the AP IP address.B . Configure the controller name.C ....

February 26, 2018 No Comments READ MORE +

While troubleshooting site-to-site VPN, you issued the show crypto ipsec sa command. What does the given output show?

Refer to the exhibit. While troubleshooting site-to-site VPN, you issued the show crypto ipsec sa command. What does the given output show?A . IPSec Phase 2 is established between 10.1.1.1 and 10.1.1.5.B . ISAKMP security associations are established between 10.1.1.5 and 10.1.1.1.C . IKE version 2 security associations are established...

February 26, 2018 No Comments READ MORE +

Which network device creates and sends the initial packet of a session?

Which network device creates and sends the initial packet of a session?A . sourceB . originationC . destinationD . networkView AnswerAnswer: A

February 26, 2018 No Comments READ MORE +

By default, what are three valid routing tables? (Choose three.)

By default, what are three valid routing tables? (Choose three.)A . inet.0B . inet4.0C . inet.6D . inet6.0E . inet.3View AnswerAnswer: A, D, E

February 26, 2018 No Comments READ MORE +

When Oceanstor 5300 V3 control box extend from 2 control to 4 control, can be used directly connected network, also can be used in a switch network

When Oceanstor 5300 V3 control box extend from 2 control to 4 control, can be used directly connected network, also can be used in a switch networkA . TRUEB . FALSEView AnswerAnswer: A

February 25, 2018 No Comments READ MORE +

Which description best describes upfade in a multipath environment?

Which description best describes upfade in a multipath environment?A . In this situation, multiple signal paths are not sent at exactly the same time. The receiver receives a positive crest on the primary signal and a negative crest on the secondary signal.B . In this situation, the multiple signal paths...

February 25, 2018 No Comments READ MORE +

Which of the following factors does not belong to the“cell unavailable due to system reasons”?

Which of the following factors does not belong to the“cell unavailable due to system reasons”?A . CPRI link failureB . RF unit transceiver channel failureC . MML as an occlusion cellD . Clock resources are not availableView AnswerAnswer: C

February 25, 2018 No Comments READ MORE +

Which of the following devices would BEST direct traffic to the remote sites?

A network administrator needs to transmit traffic to geographically diverse sites to improve performance. Which of the following devices would BEST direct traffic to the remote sites?A . HubB . BridgeC . SwitchD . RouterView AnswerAnswer: D

February 25, 2018 No Comments READ MORE +