- All Exams Instant Download
What are three components that populate the Ethernet switching table? (Choose three.)
What are three components that populate the Ethernet switching table? (Choose three.)A . the interface on which the traffic was receivedB . the MAC address of the destination nodeC . the MAC address of the source nodeD . the link stateE . the time the address was learnedView AnswerAnswer: ACE
What is causing the problem, as shown in the exhibit?
Click the Exhibit button. You are performing network tests and notice that the Layer 3 interface in the Finance VLAN on an EX Series switch is not responding to pings. You review the device status from the console. What is causing the problem, as shown in the exhibit?A . There...
Referring to the exhibit, which two statement are true?
Click the Exhibit button. Referring to the exhibit, which two statement are true? (Choose two.)A . The device will not form adjacencies with devices in a different area.B . The Level 2 database will be empty.C . The IS-IS protocol is disabled on the device.D . The device will not...
Which command would be used to perform the manual RE switchover?
You received an alert from your monitoring system that the master Routing Engine (RE) on an EX4300 switch in a virtual chassis has hardware issues and might need to be replaced. Because the switch already had graceful Routing Engine switchover (GRES) enabled and configured, you must perform a manual switchover...
Which LSA type describes the router ID of ASBR routers located in remote areas?
Which LSA type describes the router ID of ASBR routers located in remote areas?A . Type 4B . Type 5C . Type 3D . Type 7View AnswerAnswer: A
In this scenario, which type of area should you define?
You are currently defining a new OSPF area. The area must advertise external routes but should not receive external routes from another area. In this scenario, which type of area should you define?A . stubB . backboneC . not-so-stubbyD . totally stubbyView AnswerAnswer: A
Referring to exhibit, what is the problem?
Click the Exhibit button. The IS-IS adjacency between routers R1 and R2 will not establish. Referring to exhibit, what is the problem?A . The ISO address is not configured on interface ge-0/0/1.B . The level is not configured under protocols isis.C . The IP address is not configured on interface...
Which three statements are true regarding not-so-stubby areas (NSSAs)? (Choose three.)
Which three statements are true regarding not-so-stubby areas (NSSAs)? (Choose three.) A. You cannot configure an area as both an NSSA and a stub area. B. An NSSA exports an external route to the backbone area as a Type 5 LSA. C. An NSSA exports an external route as a...
Referring to the exhibit, what must be changed in the configuration?
Click the Exhibit button. You are unable to establish a BGP session between R2 and ISP-B. Referring to the exhibit, what must be changed in the configuration?A . A local address statement with the lo0 address must be added to R2 under group external-a.B . An import policy statement must...
What will be two results of the OSPF configuration shown in the exhibit?
Click the Exhibit button. What will be two results of the OSPF configuration shown in the exhibit? (Choose two.) A. A default route will be advertised into Area 1 as a Type 7 LSA. B. Area 0 will not generate summary LSAs for networks in Area 1. C. There will...
