- All Exams Instant Download
What are two characteristics of a typical EBGP underlay fabric? (Choose two.)
What are two characteristics of a typical EBGP underlay fabric? (Choose two.)A . Each device in an EBGP fabric will be configured in its own unique private AS.B . Each device in an EBGP fabric will be configured to be part of the same private AS.C . An EBGP fabric...
In OSPF, which command is commonly used to monitor neighbor relationships?
In OSPF, which command is commonly used to monitor neighbor relationships?A . show ip ospf neighborsB . show ospf databaseC . show ip route ospfD . show ospf interfacesView AnswerAnswer: A
What protocol and port does BGP use for control plane communication?
What protocol and port does BGP use for control plane communication?A . protocol TCP, port 179B . protocol UDP, port 179C . protocol TCP, port 159D . protocol UDP, port 159View AnswerAnswer: A
What are the different OSPF area types? (Choose two)
What are the different OSPF area types? (Choose two)A . Stub AreaB . Not-So-Stubby Area (NSSA)C . Default-Free ZoneD . Virtual Link AreaView AnswerAnswer: AB
Bidirectional Forwarding Detection (BFD) is primarily used for:
Bidirectional Forwarding Detection (BFD) is primarily used for:A . Encrypting data packetsB . Detecting slow links in the networkC . Quick failure detection in forwarding pathsD . Aggregating multiple linksView AnswerAnswer: C
What is the purpose of using route reflectors in BGP?
What is the purpose of using route reflectors in BGP?A . To encrypt BGP messagesB . To reduce the number of required IBGP sessions in a networkC . To increase the speed of BGP convergenceD . To automatically select the best routeView AnswerAnswer: B
Which two statements are correct about BGP? (Choose two.)
Which two statements are correct about BGP? (Choose two.)A . IBGP peers do not advertise routes learned from IBGP peers to other IBGP peers.B . EBGP uses the AS path to avoid loops.C . IBGP sessions are typically established between physical router interfaces.D . EBGP sessions are typically established between...
What is the primary purpose of using aggregate routes in a network?
What is the primary purpose of using aggregate routes in a network?A . To dynamically adjust to network changesB . To summarize and reduce the number of routes in the routing tableC . To filter unwanted trafficD . To statically define a route to a specific destinationView AnswerAnswer: B
In the Junos OS, what is the default behavior of a switch when it receives a frame with an unknown destination MAC address?
In the Junos OS, what is the default behavior of a switch when it receives a frame with an unknown destination MAC address?A . It discards the frame.B . It floods the frame out of all ports except the one it was received on.C . It sends the frame to...
How can OSPF be configured to prefer one route over another?
How can OSPF be configured to prefer one route over another?A . By setting a higher cost on the preferred route.B . By configuring route redistribution.C . By adjusting interface bandwidth.D . By setting a lower cost on the preferred route.View AnswerAnswer: D
