JN0-104

Which command produced the output shown in the exhibit? A . Show interfaces summaryB . Show interfaces filtersC . Show interfaces extensiveD . Show interfaces terseView AnswerAnswer: D

Which three statements describe the Transmission Control Protocol (TCP)? (Choose three.)A . TCP is a transport layer protocol.B . TCP is faster than the User Datagram Protocol (UDP).C . TCP provides delivery notification and error-checking mechanisms.D . TCP uses a best-effort delivery approach.E . TCP application examples include HTTP and...

What does the output of the show route forwarding-table command display?A . The routing protocol databases in the Routing EngineB . The inactive entries in the Routing Engine’s routing tableC . The Routing Engine’s forwarding tableD . The Packet Forwarding Engine routing tableView AnswerAnswer: D

Which two interfaces are considered physical interfaces? (Choose two.)A . xe-10/2/1B . ge-0/0/0C . et-3/0/0/0:0.501D . et-7/1/4.0View AnswerAnswer: A,B

What is the default route preference for OSPF internal?A . 100B . 150C . 5D . 10View AnswerAnswer: D

What are two examples of transit traffic? (Choose two.)A . SCP traffic that is destined for the router's loopback interface.B . SCP traffic that enters one interface and exits another interface on the local router.C . SFTP traffic that enters and exits the same interface on the local router.D ....

Refer to Exhibit: Which parameter at the end of the command would provide information for troubleshooting pusposes?A . No-timestampB . ExtensiveC . Print-asciiD . No-resolveView AnswerAnswer: B

Referring to the exhibit, what happens when ping packets are sent to management interface address of the local router? A . The ping packets are silently discardedB . An ICMP unreachable message is returnedC . The Ping packets are acceptedD . An ICMP redirect message is returnedView AnswerAnswer: D

How would you change the display so that 40 lines will be displayed in the terminal program when you are logged into a Junos device?A . Issue the set cli screen-length 40 command from operational mode.B . Issue the set cli screen-length 40 command from configuration modeC . Set the...

Which command displays all IPv4 routes in the default routing instance?A . show route table inet.0B . show route table inet.2C . show route table inet6.0D . show route table inet.1View AnswerAnswer: A