Which process is responsible for the configuration of the router and all user commands on a Junos device?

Which process is responsible for the configuration of the router and all user commands on a Junos device?A . rpdB . chassisdC . dcdD . mgdView AnswerAnswer: D

May 4, 2018 No Comments READ MORE +

Which two commands are required?

Topic 3, Volume C You have been asked to configure your router to send link-related SNMP trap notifications to the network management system (NMS) located at address 172.16.17.1. Which two commands are required? (Choose two.)A . set snmp trap-group my-trap-group targets 172.16.17.1B . set snmp targets 172.16.17.1C . set snmp...

May 4, 2018 No Comments READ MORE +

Which command displays this information?

A network administrator wants to verify the active alarms on interface so-0/0/0.0. Which command displays this information?A . show interfaces alarmsB . show interfaces terseC . show alarms extensiveD . show interfaces extensiveView AnswerAnswer: D

May 2, 2018 No Comments READ MORE +

During a password recovery, what is the next step after configuring the system to boot into single-user mode?

During a password recovery, what is the next step after configuring the system to boot into single-user mode?A . Reset the root password.B . Press the space bar.C . Type recovery.D . Press the "Enter" key.View AnswerAnswer: C

May 2, 2018 No Comments READ MORE +

Which two Junos platforms provide stateful firewall functionality? (Choose two.)

Which two Junos platforms provide stateful firewall functionality? (Choose two.)A . MX SeriesB . EX SeriesC . SRX SeriesD . QFX SeriesView AnswerAnswer: A, C

May 1, 2018 No Comments READ MORE +

What is the role of route preference?

What is the role of route preference?A . It is used as a tiebreaker when the same prefix is available through multiple protocols.B . It is used to determine the preferred path to a given destination.C . It is used to select the best route between multiple equal-cost paths.D ....

April 27, 2018 No Comments READ MORE +

What are two ways that packet fragmentation is handled differently between IPv6 and IPv4? (Choose two.)

What are two ways that packet fragmentation is handled differently between IPv6 and IPv4? (Choose two.)A . End hosts determine the path MTU for IPv6.B . End hosts determine the path MTU for IPv4.C . Packet fragmentation occurs at intermediate nodes for IPv4.D . Packet fragmentation occurs at intermediate nodes...

April 27, 2018 No Comments READ MORE +

What will happen when it is processed by the firewall filter shown in the exhibit?

1.1/32; } protocoltcp; port telnet; } then { sample; accept; } } } } -- Exhibit -- A Telnet session is initiated from host 10.1.1.1. What will happen when it is processed by the firewall filter shown in the exhibit?A . The packet will be accepted and logged.B . The...

April 25, 2018 No Comments READ MORE +

Which two statements are true about terms in a routing policy? (Choose two.)

Which two statements are true about terms in a routing policy? (Choose two.)A . A routing policy cannot have more than one term.B . If a term does not contain a from statement, all routes match.C . If a term does not contain a from statement, the Junos OS will...

April 25, 2018 No Comments READ MORE +

What represents the binary equivalence of 207?

What represents the binary equivalence of 207?A . 11001111B . 11101011C . 11010111D . 11010101View AnswerAnswer: A

April 23, 2018 No Comments READ MORE +