Juniper JN0-649 Enterprise Routing and Switching Professional (JNCIP-ENT) Online Training
Juniper JN0-649 Online Training
The questions for JN0-649 were last updated at Dec 24,2024.
- Exam Code: JN0-649
- Exam Name: Enterprise Routing and Switching Professional (JNCIP-ENT)
- Certification Provider: Juniper
- Latest update: Dec 24,2024
You are troubleshooting a BGP connection.
Referring to the exhibit, which two statements are correct? (Choose two.)
- A . Packet fragmentation is preventing the session from establishing.
- B . The 192.168.1.5 peer has a misconfigured MD5 key.
- C . The ge-0/0/1 interface is disabled.
- D . The 192.168.1.4 peer has a misconfigured autonomous system number.
You are deploying IP phones in your enterprise network that must receive their power through their Ethernet connection. You are using your EX Series switch’s PoE ports that support IEEE 802.3af.
In this scenario, what is the maximum amount of power allocated to each interface?
- A . 10.2 W
- B . 15.4 W
- C . 30 W
- D . 50 W
Referring to the exhibit, which statement is correct when a failure exists on the link between host2 and switch5 on this EVPN-VXLAN fabric?
- A . The switch5 device will send a Type 2 route to all peers.
- B . The switch5 device will send a Type 4 route to all peers.
- C . The switch5 device will send a Type 1 route to all peers.
- D . The switch5 device will send a Type 3 route to all peers.
Referring to the exhibit, which two statements are correct? (Choose two.)
- A . The host that the route is associated with is multihomed to two leaf nodes.
- B . The route is a Type 1 EVPN route.
- C . The route is a Type 2 EVPN route.
- D . The host that the route is associated with is single-homed to one leaf node.
Which three configuration parameters must match on all switches within the same MSTP region? (Choose three.)
- A . VLAN to instance mapping
- B . revision level
- C . configuration name
- D . bridge priority
- E . region name
You recently committed a change to a router to reject OSPF routes sourced from area 10.
However, you are still seeing area 10 routes in the routing table.
Referring to the exhibit, which statement is correct?
- A . The OSPF protocol is first matched by find-ospf and accepted.
- B . The routes only timeout after 24 hours.
- C . The routes remain in the table until the device is rebooted.
- D . The routes remain in the table until the routing daemon is restarted.
Referring to the exhibit, traffic ingresses on interface ge-0/0/3 and egresses on interface ge-0/0/4.
Which queue does traffic with the IP precedence value of 100 use?
- A . network-control
- B . assured-forwarding
- C . best-effort
- D . expedited-forwarding
You are running OSPF as your IGP. The interfaces connecting two routers are in the ExStart state. You notice that something is incorrect with the configuration.
Referring to the exhibit, which statement is correct?
- A . The subnet mask is incorrect.
- B . The MTU setting are incorrect.
- C . The interface type is incorrect.
- D . The IP addresses are incorrect.
The connection between DC1 and DC2 is routed as shown in the exhibit.
In this scenario, which statement is correct?
- A . The border devices must be able to perform Layer 3 routing and provide IRB functionality.
- B . L3VPN must be enabled to advertise reachability.
- C . An IP prefix route provides encoding for intra-subnet forwarding.
- D . Type 2 and Type 5 routes will be exchanged between DC1 and DC2.
You are asked to enforce user authentication using a captive portal before users access the corporate network.
Which statement is correct in this scenario?
- A . HTTPS is the default protocol for a captive portal.
- B . A captive portal can be bypassed using an allowlist command containing a device’s IP address.
- C . When enabled, a captive portal must be applied to each individual interface.
- D . All Web browser requests are redirected to the captive portal until authentication is successful.
Latest JN0-649 Dumps Valid Version with 65 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
