InJuniper Apstra. which three modes are available fordevices? (Choose three.)

InJuniper Apstra. which three modes are available fordevices? (Choose three.)
A . Deploy
B . Active
C . Stopped
D . Drain
E . Ready

View Answer

Answer: A D E

Explanation:

Juniper Apstra supports three deploy modes for devices: Deploy, Drain, and Ready. These modes determine the configuration and state of the devices in the data center fabric12.

Deploy: This mode applies the full Apstra-rendered configuration to the device, according to the Apstra Reference Design. The device state becomes IS-ACTIVE and the device is ready to carry traffic in the fabric12.

– Drain: This mode adds a “drain” configuration to the device, which prevents any new traffic from entering the device. The device state becomes IS-READY and the device is prepared for maintenance or decommissioning12.

– Ready: This mode removes the Apstra-rendered configuration from the device, leaving only the basic configuration such as device hostname, interface descriptions, and port speed/breakout. The device state becomes IS-READY and the device is not part of the fabric12.

References:

– Device Configuration Lifecycle

– Set Deploy Mode (Datacenter)