In the switching network shown in the figure, VLAN10 is set as Super VLAN on switch SWA, VLAN2 and VLAN3 are sub VLANs of VLAN10, port Ethernet1/0/3 is a Trunk port, PVID is VLAN1, and all VLANs are allowed to pass; VLAN2~VLAN20 are created on switch SWB, port Ethernet1/0/4 is a Trunk port, PVID is VLAN1, and all VLANs are allowed to pass. Check the Ethernet 1/0/3 port information on SWA, which of the following is the correct display?
A . [SWA] display interface Ethernet 1/0/3 Ethernet1/0/3 current state: UP
PVID: 1
Mdi type: auto
Link delay is 0 （ sec ） Port link-type: trunk
VLAN passing: 1 （ default vlan ）， 2-3 ， 10 VLAN permitted: 1 （ default vlan ）， 2-4094 Trunk port encapsulation: IEEE 802.1q
B . [SWA] display interface Ethernet 1/0/3 Ethernet1/0/3 current state: UP ……
PVID: 1
Mdi type: auto
Link delay is 0 （ sec ） Port link-type: trunk
VLAN passing: 1 （ default vlan ）， 2-3
VLAN permitted: 1 （ default vlan ）， 2-9 ， 11-4094 Trunk port encapsulation: IEEE 802.1q
C . [SWA] display interface Ethernet 1/0/3 Ethernet1/0/3 current state: UP ……
PVID: 1
Mdi type: auto
Link delay is 0 (sec)Port link-type: trunk
VLAN passing: 1 (default vlan), 2
VLAN permitted: 1 (default vlan), 2-9, 11-4094 Trunk port encapsulation: IEEE 802.1q
D . [SWA] display interface Ethernet 1/0/3 Ethernet1/0/3 current state: UP ……
PVID: 1
Mdi type: auto
Link delay is 0 (sec)Port link-type: trunk
VLAN passing: 1 (default vlan), 2
VLAN permitted: 1 (default vlan), 2-4094
Trunk port encapsulation: IEEE 802.1q
Answer: B
Latest GB0-372-ENU Dumps Valid Version with 432 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund