- All Exams Instant Download
The following is part of the router RTA configuration, for the configuration description of this part, the correct is: (Multiple Choice)
The following is part of the router RTA configuration, for the configuration description of this part, the correct is: (Multiple Choice) A. A. Disable OSPF packet sending on interface gigabitethernet 1/0/0 B. The interface cannot send HELLO messages C. The direct route of interface gigabitethernet 1/0/0 can still be advertised...
In the same LAN, if some IGMPv1 routers exist in the LAN, IGMPv1 must be forcibly configured for all routers in the subnet to use normally.
In the same LAN, if some IGMPv1 routers exist in the LAN, IGMPv1 must be forcibly configured for all routers in the subnet to use normally.A . TrueB . FalseView AnswerAnswer: A
Which of the following can't inject local routes into BGP? (Multiple choices)
Which of the following can't inject local routes into BGP? (Multiple choices)A . Through the network commandB . Receive Routes from PeersC . Through summary automatic commandD . Through import commandView AnswerAnswer: BC
The description of the LSA header information in the AS-External-LSA of OSPF, which is wrong?
The description of the LSA header information in the AS-External-LSA of OSPF, which is wrong?A . Link State ID indicates the destination network address.B . Advertising Router indicates the router ID of ASBD . Net mask indicates the network mask of the destination network segment.E . Forwarding Address is always...
About multicast routing, which are correct? (Multiple choices)
About multicast routing, which are correct? (Multiple choices)A . Multicast routing protocols are used to establish and maintain multicast routes and forward multicast packets correctly and efficiently.B . Multicast routing forms a one-way loop-free data transmission path from a data source to multiple receivers, that is, a multicast distribution tree.C...
When two routers establish a logical BGP peer through multiple physical links, you must use the peer connect-interface command.
When two routers establish a logical BGP peer through multiple physical links, you must use the peer connect-interface command.A . TrueB . FalseView AnswerAnswer: A
In the RSTP network as shown in the figure, according to the configuration of the SWC in the figure, it can be determined that the type of the E0/1 port of the SWC is: (Multiple Choice)
In the RSTP network as shown in the figure, according to the configuration of the SWC in the figure, it can be determined that the type of the E0/1 port of the SWC is: (Multiple Choice) A . Designated portB . Root portC . Alternate PortD . Edge portView AnswerAnswer:...
Autonomous System (AS) refers to a set of routers defined by users and using a unified routing policy.
Autonomous System (AS) refers to a set of routers defined by users and using a unified routing policy.A . TrueB . FalseView AnswerAnswer: B
When an operating OSPF router receives an LSA and the LSA does not exist in its link state database, how does the router handle this LSA?
When an operating OSPF router receives an LSA and the LSA does not exist in its link state database, how does the router handle this LSA?A . The router will silently discard this LSA without returning any messages.B . This LSA will be immediately flooded to other OSPF neighbors.C ....
About the description of MUX VLAN, which is wrong?
About the description of MUX VLAN, which is wrong?A . Each Group VLAN must have a Principal VLAN bound to it.B . If the VLAN ID is already used for the principal VLAN, the VLAN can no longer be used for VLANIF interfaces, super VLANs and sub VLANs.C . After...
