- All Exams Instant Download
How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?
How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?A . "The optimal rate for sending multicast frames is based on the highest broadcast rate across all associated clientsB . When this option is enabled the minimum default rate for multicast traffic is set to 12 Mbps for...
What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?
You are deploying a bonded 40 MHz wide channel. What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?A . 2dBB . 3dBC . 8dBD . 4dBView AnswerAnswer: B Explanation: The difference in the noise floor...
What is true regarding 802.11k?
What is true regarding 802.11k?A . It extends radio measurements to define mechanisms for wireless network management of stationsB . It reduces roaming delay by pre-authenticating clients with multiple target APs before a client roams to an APC . It provides mechanisms for APs and clients to dynamically measure the...
Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device.
Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device. The following configuration was created on the switch: A) B) C) D) A . Option AB . Option BC . Option CD . Option DView AnswerAnswer: C Explanation: The correct configuration...
Which technology minimizes flooding so the legacy application can work efficiently?
A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. The legacy devices are connected to Aruba CX 6300 switches throughout the campus. Which technology minimizes flooding so the legacy application can...
Which command lists will satisfy the requirements with the least number of commands?
You are configuring an SVI on an Aruba CX switch that needs to have the following characteristics: * VLANID = 25 . IPv4 address 10 105 43 1 with mask 255 255 255.0 * IPv6 address fd00:5708::f02d:4df6 with a 64 bit prefix length * member of VRF eng * VRF...
What is the order of operations tor Key Management service for a wireless client roaming from AP1 to AP2?
What is the order of operations tor Key Management service for a wireless client roaming from AP1 to AP2? View AnswerAnswer: Explanation: https://www.arubanetworks.com/techdocs/Instant_85_WebHelp/Content/instant-ug/wlan-ssid-conf/conf-fast-roa
What are two parts of the solution for these requirements?
You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new default route to 10.1.1.253. Other non-default routes for this subnet should not be affected by this change. What are...
Match the terms below to their characteristics (Options may be used more than once or not at all.)
Match the terms below to their characteristics (Options may be used more than once or not at all.) View AnswerAnswer: Explanation: a) A device with IP address 10.1.3.7 in a network wants to send the traffic stream to a device with IP address 10.13.4.2 in the other network -> Unicast...
Match the solution components of NetConductor (Options may be used more than once or not at all.)
Match the solution components of NetConductor (Options may be used more than once or not at all.) View AnswerAnswer: Explanation: Client Insights matches with Built in , AI powered client visibility and fingerprinting capability that leverages infrastructure telemetry and ML based classification models to eliminate network bling spots Client Insights...
