- All Exams Instant Download
What is the correct configuration to ensure that APs will work properly?
A system engineer needs to preconfigure several Aruba CX 6300 switches that will be sent to a remote office An untrained local field technician will do the rollout of the switches and the mounting of several AP-515s and AP-575S. Cables running to theAPs are not labeled. The VLANs are already...
What is the benefit of VSX clustering with the new solution?
The customer needs a network hardware refresh to replace an aging Aruba 5406R core switch pair using spanning tree configuration with Aruba CX 8360-32YC switches. What is the benefit of VSX clustering with the new solution?A . stacked data-plane B. faster MSTP converge processing C. dual Aruba AP LAN port...
What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?
What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?A . Implement a control plane ACL to limit access to approved IPs and/or subnets B. Manually enable Enhanced Security Mode from a console session. C. Disable all management services...
What is the solution for this?
A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802 1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches...
What is correct about access from the servers to the Core?
Two AOS-CX switches are configured with VSX at the the Access-Aggregation layer where servers attach to them An SVI interface is configured for VLAN 10 and serves as the default gateway for VLAN 10. The ISL link between the switches fails, but the keepalive interface functions. Active gateway has been...
How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?
How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network? A. "The optimal rate for sending multicast frames is based on the highest broadcast rate across all associated clients B. When this option is enabled the minimum default rate for multicast traffic is set to 12 Mbps for...
What is an OSPF transit network?
What is an OSPF transit network? A. a network that uses tunnels to connect two areas B. a special network that connects two different areas C. a network on which a router discovers at least one neighbor D. a network that connects to a different routing protocolView AnswerAnswer: C Explanation:...
What is true regarding 802.11k?
What is true regarding 802.11k?A . It extends radio measurements to define mechanisms for wireless network management of stations B. It reduces roaming delay by pre-authenticating clients with multiple target APs before a client roams to an AP C. It provides mechanisms for APs and clients to dynamically measure the...
Which technology is the best match for this use case?
A new network design is being considered to minimize client latency in a high-density environment. The design needs to do this by eliminating contention overhead by dedicating subcamers to clients. Which technology is the best match for this use case?A . OFDMA B. MU-MIMO C. QWMM D. Channel BondingView AnswerAnswer:...
What are two parts of the solution for these requirements?
You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new default route to 10.1.1.253. Other non-default routes for this subnet should not be affected by this change. What are...
