Which flew in a Layer 3 IPv4 packet header is used to mitigate Layer 3 route loops?

Which flew in a Layer 3 IPv4 packet header is used to mitigate Layer 3 route loops?A . ChecksumB . Time To LiveC . ProtocolD . Destination IPView AnswerAnswer: B Explanation: The field in a Layer 3 IPv4 packet header that is used to mitigate Layer 3 route loops is...

September 13, 2024 No Comments READ MORE +

Match the feature to the Aruba OS version (Matches may be used more than once.)

Match the feature to the Aruba OS version (Matches may be used more than once.) View AnswerAnswer: Explanation: Features: 1) Clustered Instant Access Points Aruba OS version: a) Aruba OS 8 Features: 2) Dynamic Radius Proxy Aruba OS version: a) Aruba OS 8 Features: 3) Scales to more than 10,000...

September 12, 2024 No Comments READ MORE +

What is the Signal to Noise Ratio?

The noise floor measures 000000001 milliwatts, and the receiver's signal strength is -65dBm. What is the Signal to Noise Ratio?A . 35 dBmB . 15 dBmC . 45 dBmD . 25 dBmView AnswerAnswer: D

September 12, 2024 No Comments READ MORE +

Which dashboard can be used to view and acknowledge issues when beginning the troubleshooting process?

A network technician is using Aruba Central to troubleshoot network issues. Which dashboard can be used to view and acknowledge issues when beginning the troubleshooting process?A . the Alerts and Events dashboardB . the Audit Trail dashboardC . the Reports dashboardD . the Tools dashboardView AnswerAnswer: A Explanation: The Alerts...

September 11, 2024 No Comments READ MORE +

When would you bond multiple 20MHz wide 802.11 channels?

When would you bond multiple 20MHz wide 802.11 channels?A . To decrease the Signal to Noise Ratio (SNR)B . To increase throughput between the client and APC . To provision highly available AP groupsD . To utilize high gain omni-directional antennasView AnswerAnswer: B Explanation: Bonding multiple 20MHz wide 802.11 channels...

September 10, 2024 No Comments READ MORE +

What is the best technology to use for this task?

You need to drop excessive broadcast traffic on ingress to an ArubaOS-CX switch. What is the best technology to use for this task?A . Rate limitingB . DWRR queuingC . QoS shapingD . Strict queuingView AnswerAnswer: A Explanation: The best technology to use for dropping excessive broadcast traffic on ingress...

September 8, 2024 No Comments READ MORE +

Please match the use case to the appropriate authentication technology

Please match the use case to the appropriate authentication technology View AnswerAnswer: Explanation: Based on the information provided, here are the matches for the use case to the appropriate authentication technology: ClearPass Policy Manager: Authenticate users on corporate-owned Chromebook devices using 802.1X and context gathered from the network devices that...

September 6, 2024 No Comments READ MORE +

What are two advantages of a UXl? (Select two.)

What are two advantages of a UXl? (Select two.)A . A UXl can be used without any internet connectionB . A UXl helps to calculate the best WiFi channels in a remote locationC . A UXl behaves like a client/userD . A UXl measures the Wi-Fi coverage of all APs...

September 5, 2024 No Comments READ MORE +

What is the nature and behavior of the Virtual IP for the VSX pair if clients are connected to the access switch using VSX as the default gateway?

Refer to the exhibit. In the given topology, a pair of Aruba CX 8325 switches are in a VSX stack using the active gateway. What is the nature and behavior of the Virtual IP for the VSX pair if clients are connected to the access switch using VSX as the...

September 5, 2024 No Comments READ MORE +

Which configuration script will achieve the task?

Make sure the interfaces are all ON. Which configuration script will achieve the task?A . Edge1# conf t vlan 20 name Mgmt interface vlan 20 ip address 10.1.1.10/24 no shut interface lag 1 shut vlan access 20 lacp mode active Int 1/1/51.1/1/52 shut no routing lag 1 interface lag 1...

September 5, 2024 No Comments READ MORE +