HPE6-A73 V3

A network engineer is using NetEdit to manage AOS-CX switches. The engineer notices that a lot of thirdparty VoIP phones are showing up in the NetEdit topology. The engineer deletes these, but they are automatically rediscovered by NetEdit and added back in. What should the administrator do to solve this...

Examine the attached diagram. The two PCs are located in VLAN 11 (10.1.11.0/24). Which example defines how to implement active gateway on the VSX core for VLAN 11?A . interface vlan 11 active-gateway ip 10.1.11.1 active-gateway mac 02:02:00:00:01:00B . interface lag 254 active-gateway vlan 11 ip 10.1.11.1 active-gateway vlan 11...

What is correct regarding the tunneling of user traffic between AOS-CX switches and Aruba Mobility Controllers (MCs)?A . Uses IPSec to protect the management and data trafficB . Uses IPSec to protect the management trafficC . Supports only port-based tunnelingD . Uses the same management protocol as Aruba APsView AnswerAnswer:...

Examine the following AOS-CX switch configuration: Which statement correctly describes what is allowed for traffic entering interface 1/1/3?A . IP traffic from 10.1.11.0/24 is allowed to access 10.1.110.0/24B . IP traffic from 10.0.11.0/24 is allowed to access 10.1.12.0/24C . Traffic from 10.0.12.0/24 will generate a log record when accessing 10.0.11.0/24D...

How is voice traffic prioritized correctly on AOS-CX switches?A . By defining device profiles with QOS settingsB . By placing it in the strict priority queueC . By implementing voice VLANsD . By implementing weighted fair queueing (WFQ)View AnswerAnswer: B

An administrator is concerned about the security of the control plane connection between an AOS-CX switch and an Aruba Mobility Controller (MC) when implementing user-based tunneling. How should the administrator protect this traffic?A . IPSec with a digital certificateB . GRE with a pre-shared keyC . PAPI with an MD5...

Examine the network exhibit: The ACL configuration defined on Core-1 is as follows: If telnet was being used, which device connection would be permitted and functional in both directions? (Choose two.)A . Client 3 to Client 2B . Client 1 to Client 2C . Server 2 to Client 2D ....

Examine the configuration performed on newly deployed AOS-CX switches: After performing this configuration, the administrator notices that the switch ports always remain in the EAP start state. What should the administrator do to fix this problem?A . Define the server group cppmB . Set the ports to client-modeC . Create...

A network administrator is implementing a configuration plan in NetEdit. The administrator used NetEdit to push the configuration plan to the switch. Which option in the NetEdit planning section should the administrator select to save the configuration running on the switch to the startup-config?A . EDITB . VALIDATEC . COMMITD...

An administrator is replacing the current access switches with AOS-CX switches. The access layer switches must authenticate user and networking devices connecting to them. Some devices support no form of authentication, and some support 802.1X. Some ports have a VoIP phone and a PC connected to the same port, where...