HPE6-A72

What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?A . backup secondary sftp://[email protected]/GB . 10.04.0003.swiC . copy secondary sftp://[email protected]/GD . 10.04.0003.swiE . copy sftp://[email protected]/GF . 10.04.0003.swi secondaryG . copy secondary tftp://[email protected]/GH . 10.04.0003.swiView AnswerAnswer: B

The section in blue can be ignored. SW1(config)# interface 1/1/1-1/1/2 SW1(config-if-<1/1/1-1/1/2)# vlan access 2 SW1(config-if-<1/1/1-1/1/2)# exit SW1(config)# interface 1/1/11-1/1/17 SW1(config-if-<1/1/11-1/1/17)# vlan access 17 SW1(config-if-<1/1/11-1/1/17)# exit After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added? A . Option AB...

Refer to the exhibit. You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master. What is a valid configuration for Access-2 to join the VSF stack?A . Access-2# configure Access-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2...

What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)A . Management interface split detectionB . Peer switch-based detectionC . Loopback keepalivesD . ARP-basedE . BFDView AnswerAnswer: A,D

Which security benefit does SNMPv3 offer that SNMPv2 does not offer?A . SSL encryptionB . ScopesC . Data confidentiallyD . RADIUS groupsView AnswerAnswer: C

Refer to the exhibit. Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN. Which configuration will correct the issue?A . Core-2(config)# ip route 0.0.0.0/0 10.1.1.1 vrf GREEN Host-B: assign the default-gateway address 10.1.20.181B . Core-1(config)# ip route...

DRAG DROP Match the term to the correct description. View AnswerAnswer:

Refer to the exhibit. The above output is the result of issuing the command show system resource-utilization. What command should be used to enable terminal output line by line or page by page?A . The command pageB . The command terminal length 30C . The command moreD . The command...

Which two options are correct regarding the IEEE 802.11ax standard? (Choose two.)A . allows transmissions of up to 4.8GbpsB . is an emerging satellite connection standard to allow wireless access anywhere in the worldC . operates only in the 5GHz similar to 802.11acD . operates in both the 2.4GHz and...

Which two statements accurately describe the features of NetEdit? (Choose two.)A . NetEdit can be used to configure and validate any third-party device that supports SSH and REST access.B . NetEdit includes trial licensing for up to 10 nodes.C . NetEdit can perform configuration and compliance validation.D . NetEdit supports...